ACME has a "real" PC and a "pseudo" PC. The "real" PC determines the
initial position in a 64KB buffer used to hold assembler output. If
the amount of code generated runs off the end, the assembler fails
with "produced too much code".
The source code generator in SourceGen was outputting a "real" PC
for the first address range and "psuedo" PCs for any address ranges
that followed. This produced nice results for code with a single
range, but caused problems for multi-range sources if the initial
range was high in memory and a later range was lower in memory.
While the assembler isn't actually generating more than 64KB of code,
ACME's buffer management was detecting an overflow.
Now, if a source file has multiple address ranges, we set the "real"
PC to $0000 and use a "pseudo" PC for all ranges. Output for projects
with a single address range is unmodified.
The label localizer is now always on. The regression tests turned
it off by default, but that's no longer allowed, so the generated
output has changed for many of them. The tests themselves were not
altered.
The code that found a nearby data target for an instruction operand
was searching backward but not forward. We now take one step
forward, so that "LDA TABLE-1,Y" fills in automatically.
This altered 2008-address-changes, which had just this situation.
It didn't alter 2010-target-adjustment, but the existing tests were
insufficient and have been improved.
Implement multi-byte project/platform symbols by filling out a table
of addresses. Each symbol is "painted" into the table, replacing
an existing entry if the new entry has higher priority. This allows
us to handle overlapping entries, giving boosted priority to platform
symbols that are defined in .sym65 files loaded later.
The bounds on project/platform symbols are now rigidly defined. If
the "nearby" feature is enabled, references to SYM-1 will be picked
up, but we won't go hunting for SYM+1 unless the symbol is at least
two bytes wide.
The cost of adding a symbol to the symbol table is about the same,
but we don't have a quick way to remove a symbol.
Previously, if two platform symbols had the same value, the symbol
with the alphabetically lowest label would win. Now, the symbol
defined in the most-recently-loaded file wins. (If you define two
symbols with the same value in the same file, it's still resolved
alphabetically.) This allows the user to pick the winner by
arranging the load order of the platform symbol files.
Platform symbols now keep a reference to the file ident of the
symbol file that defined them, so we can show the symbols's source
in the Info panel.
These changes altered the behavior of test 2008-address-changes,
which includes some tests on external addresses that are close to
labeled internal addresses. The previous behavior essentially
treated user labels as being 3 bytes wide and extending outside the
file bounds, which was mildly convenient on occasion but felt a
little skanky. (We could do with a way to define external symbols
relative to internal symbols, for things like the source address of
code that gets relocated.)
Also, re-enabled some unit tests.
Also, added a bit of identifying stuff to CrashLog.txt.
If a symbol is defined at <addr>, and we counter STA <addr>-1,Y,
we want to use the symbol in the operand. This worked for labels
but not project/platform symbols.
Also, fixed a crash that happened if you tried to delete an auto
label.
There's no easy way to make non-zero-bank 65816 code work, so I'm
punting and just generating a whole-file hex dump for those. This
renders tests 2007 and 2009 useless, so I'm hesitant to claim that
ACME support is fully functional.