acme/ACME_Lib/cbm/c64/reu.a

64 lines
2.1 KiB
Plaintext
Raw Normal View History

;ACME 0.95
!ifdef lib_cbm_c64_reu_a !eof
lib_cbm_c64_reu_a = 1
; This file contains definitions for accessing a RAM Expansion Unit (REU) of
; type 1700, 1764, 1750 and compatible. These units contain a chip called REC
; (RAM Expansion Controller) capable of direct memory access (DMA).
; Standard base address of control registers is $df00 in i/o space.
!address {
; status register
rec_status = $df00 ; reading will clear IRQ, END and ERROR bits
}
rec_STATUS_IRQ = %#.......
rec_STATUS_END = %.#......
rec_STATUS_ERROR = %..#..... ; for verify command
rec_STATUS_TYPE = %...#.... ; chip type (do not use to determine unit size!)
rec_STATUS_VERSION = %....####
!address {
; command register
rec_command = $df01
}
rec_COMMAND_EXECUTE = %#.......
;reserved = %.#......
rec_COMMAND_RELOAD = %..#.....
rec_COMMAND_IMMEDIATELY = %...#.... ; do not wait for $ff00 write
;reserved = %....##..
rec_COMMAND_MODE_MASK = %......## ; bit mask for the four modes
rec_COMMAND_MODE_STASH = %........ ; computer-to-REU
rec_COMMAND_MODE_FETCH = %.......# ; REU-to-computer
rec_COMMAND_MODE_SWAP = %......#. ; exchange
rec_COMMAND_MODE_VERIFY = %......## ; compare
rec_COMMAND_STASH = %#.#..... ; these wait for $ff00 before
rec_COMMAND_FETCH = %#.#....# ; starting and then reload values.
!address {
; internal address (computer RAM)
rec_int_low = $df02
rec_int_high = $df03
; external address (expansion RAM)
rec_ext_low = $df04
rec_ext_high = $df05
rec_ext_bank = $df06
; A stock 1700 unit has two banks (128 KiB).
; A stock 1764 unit has four banks (256 KiB).
; A stock 1750 unit has eight banks (512 KiB).
; Upgraded units and clones may have more, but the REC chip will always
; "wrap around" after eight banks if crossing bank borders!
; amount of bytes to process
rec_amount_low = $df07
rec_amount_high = $df08
; when to request interrupts
rec_irqctrl = $df09
}
rec_IRQCTRL_ENABLE = %#.......
rec_IRQCTRL_ON_END = %.#......
rec_IRQCTRL_ON_ERROR = %..#..... ; for verify errors
!address {
; address control (set to zero for normal operation)
rec_addrctrl = $df0a
}
rec_ADDRCTRL_FIX_INT = %#.......
rec_ADDRCTRL_FIX_EXT = %.#......