Swift cores implement store barriers that are stronger than the ARM
specification but weaker than general barriers. They are, in fact, just about
enough to provide the ordering needed for atomic operations with release
semantics.
This patch makes use of that quirk.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185527 91177308-0d34-0410-b5e6-96231b3b80d8
This is dead code since PIC16 was removed in 2010. The result was an odd mix,
where some parts would carefully pass it along and others would assert it was
zero (most of the object streamer for example).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185436 91177308-0d34-0410-b5e6-96231b3b80d8
According to ARM EHABI section 9.2, if the
__aeabi_unwind_cpp_pr1() or __aeabi_unwind_cpp_pr2() is
used, then the handler data must be emitted after the unwind
opcodes. The handler data consists of several words, and
should be terminated by zero.
In case that the .handlerdata directive is not specified by
the programmer, we should emit zero to terminate the handler
data.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185422 91177308-0d34-0410-b5e6-96231b3b80d8
Turns out I'd misread the architecture reference manual and thought
that was a load/store-store barrier, when it's not.
Thanks for pointing it out Eli!
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185356 91177308-0d34-0410-b5e6-96231b3b80d8
I believe the full "dmb ish" barrier is not required to guarantee release
semantics for atomic operations. The weaker "dmb ishst" prevents previous
operations being reordered with a store executed afterwards, which is enough.
A key point to note (fortunately already correct) is that this barrier alone is
*insufficient* for sequential consistency, no matter how liberally placed.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185339 91177308-0d34-0410-b5e6-96231b3b80d8
This patch assigns paired GPRs for inline asm with
64-bit data on ARM. It's enabled for both ARM and Thumb to support modifiers
like %H, %Q, %R.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185169 91177308-0d34-0410-b5e6-96231b3b80d8
We were generating intrinsics for NEON fixed-point conversions that didn't
exist (e.g. float -> i16). There are two cases to consider:
+ iN is smaller than float. In this case we can do the conversion but need an
extend or truncate as well.
+ iN is larger than float. In this case using the NEON conversion would be
incorrect so we don't perform any combining.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185158 91177308-0d34-0410-b5e6-96231b3b80d8
The mapping between SRS pseudo-instructions and SRS native instructions was incorrect, the correct mapping is:
srsfa -> srsib
srsea -> srsia
srsfd -> srsdb
srsed -> srsda
This fixes <rdar://problem/14214734>.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185155 91177308-0d34-0410-b5e6-96231b3b80d8
(Currently, ARM 'this'-returns are handled in the standard calling convention case by treating R0 as preserved and doing some extra magic in LowerCallResult; this may not apply to calling conventions added in the future so this patch provides and documents an interface for indicating such)
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185024 91177308-0d34-0410-b5e6-96231b3b80d8
Unfortunately this addresses two issues (by the time I'd disentangled the logic
it wasn't worth putting it back to half-broken):
+ Coprocessor instructions should all be predicable in Thumb mode.
+ BKPT should never be predicable.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184965 91177308-0d34-0410-b5e6-96231b3b80d8
The barrier instructions are only "always-execute" in ARM mode, they can quite
happily sit inside an IT block in Thumb.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184964 91177308-0d34-0410-b5e6-96231b3b80d8
When encoded to thumb, VFP instruction and VMOV/VDUP between scalar and
core registers, must have their predicate bit to 0b1110.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184707 91177308-0d34-0410-b5e6-96231b3b80d8
In thumb1, NOP is a pseudo-instruction equivalent to mov r8, r8.
However the disassembler should not use this alias.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184703 91177308-0d34-0410-b5e6-96231b3b80d8
A FastISel optimization was causing us to emit no information for such
parameters & when they go missing we end up emitting a different
function type. By avoiding that shortcut we not only get types correct
(very important) but also location information (handy) - even if it's
only live at the start of a function & may be clobbered later.
Reviewed/discussion by Evan Cheng & Dan Gohman.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184604 91177308-0d34-0410-b5e6-96231b3b80d8
it at the moment.
This allows to form more paired loads even when stack coloring pass destroys the
memoryoperand's value.
<rdar://problem/13978317>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184492 91177308-0d34-0410-b5e6-96231b3b80d8
The cdp2 instruction should have the same restrictions as cdp on the
co-processor registers.
VFP instructions on v8/AArch32 share the same encoding space as cdp2.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184445 91177308-0d34-0410-b5e6-96231b3b80d8
We had been papering over a problem with location info for non-trivial
types passed by value by emitting their type as references (this caused
the debugger to interpret the location information correctly, but broke
the type of the function). r183329 corrected the type information but
lead to the debugger interpreting the pointer parameter as the value -
the debug info describing the location needed an extra dereference.
Use a new flag in DIVariable to add the extra indirection (either by
promoting an existing DW_OP_reg (parameter passed in a register) to
DW_OP_breg + 0 or by adding DW_OP_deref to an existing DW_OP_breg + n
(parameter passed on the stack).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184368 91177308-0d34-0410-b5e6-96231b3b80d8
Said assert assumes that ADDC will always have a glue node as its second
argument and is checked before we even know that we are actually performing the
relevant MLAL optimization. This is incorrect since on ARM we *CAN* codegen ADDC
with a use list based second argument. Thus to have both effects, I converted
the assert to a conditional check which if it fails we do not perform the
optimization.
In terms of tests I can not produce an ADDC from the IR level until I get in my
multiprecision optimization patch which is forthcoming. The tests for said patch
would cause this assert to fail implying that said tests will provide the
relevant tests.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184230 91177308-0d34-0410-b5e6-96231b3b80d8
"When assembling to the ARM instruction set, the .N qualifier produces
an assembler error and the .W qualifier has no effect."
In the pre-matcher handler in the asm parser the ".w" (wide) qualifier
when in ARM mode is now discarded. And an error message is now
produced when the ".n" (narrow) qualifier is used in ARM mode.
Test cases for these were added.
rdar://14064574
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184224 91177308-0d34-0410-b5e6-96231b3b80d8
When using a positive offset, literal loads where encoded
as if it was negative, because:
- The sign bit was not assigned to an operand
- The addrmode_imm12 operand was not encoding the sign bit correctly
This patch also makes the assembler look at the .w/.n specifier for
loads.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184182 91177308-0d34-0410-b5e6-96231b3b80d8
This fixes two previous issues:
- Negative offsets were not correctly disassembled
- The decoded opcodes were not the right one
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184180 91177308-0d34-0410-b5e6-96231b3b80d8
Someone may want to do something crazy, like replace these objects if they
change or something.
No functionality change intended.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184175 91177308-0d34-0410-b5e6-96231b3b80d8
Frame index handling is now target-agnostic, so delete the target hooks
for creation & asm printing of target-specific addressing in DBG_VALUEs
and any related functions.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184067 91177308-0d34-0410-b5e6-96231b3b80d8
Rather than using the full power of target-specific addressing modes in
DBG_VALUEs with Frame Indicies, simply use Frame Index + Offset. This
reduces the complexity of debug info handling down to two
representations of values (reg+offset and frame index+offset) rather
than three or four.
Ideally we could ensure that frame indicies had been eliminated by the
time we reached an assembly or dwarf generation, but I haven't spent the
time to figure out where the FIs are leaking through into that & whether
there's a good place to convert them. Some FI+offset=>reg+offset
conversion is done (see PrologEpilogInserter, for example) which is
necessary for some SelectionDAG assumptions about registers, I believe,
but it might be possible to make this a more thorough conversion &
ensure there are no remaining FIs no matter how instruction selection
is performed.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184066 91177308-0d34-0410-b5e6-96231b3b80d8
Replace the ill-defined MinLatency and ILPWindow properties with
with straightforward buffer sizes:
MCSchedMode::MicroOpBufferSize
MCProcResourceDesc::BufferSize
These can be used to more precisely model instruction execution if desired.
Disabled some misched tests temporarily. They'll be reenabled in a few commits.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184032 91177308-0d34-0410-b5e6-96231b3b80d8
This is a resubmit of r182877, which was reverted because it broken
MCJIT tests on ARM. The patch leaves MCJIT on ARM as it was before: only
enabled for iOS. I've CC'ed people from the original review and revert.
FastISel was only enabled for iOS ARM and Thumb2, this patch enables it
for ARM (not Thumb2) on Linux and NaCl, but not MCJIT.
Thumb2 support needs a bit more work, mainly around register class
restrictions.
The patch punts to SelectionDAG when doing TLS relocation on non-Darwin
targets. I will fix this and other FastISel-to-SelectionDAG failures in
a separate patch.
The patch also forces FastISel to retain frame pointers: iOS always
keeps them for backtracking (so emitted code won't change because of
this), but Linux was getting much worse code that was incorrect when
using big frames (such as test-suite's lencod). I'll also fix this in a
later patch, it will probably require a peephole so that FastISel
doesn't rematerialize frame pointers back-to-back.
The test changes are straightforward, similar to:
http://lists.cs.uiuc.edu/pipermail/llvm-commits/Week-of-Mon-20130513/174279.html
They also add a vararg test that got dropped in that change.
I ran all of lnt test-suite on A15 hardware with --optimize-option=-O0
and all the tests pass. All the tests also pass on x86 make check-all. I
also re-ran the check-all tests that failed on ARM, and they all seem to
pass.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@183966 91177308-0d34-0410-b5e6-96231b3b80d8
