It's possible to have a prior definition of a symbol in module asm.
Raise an error instead of crashing.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224828 91177308-0d34-0410-b5e6-96231b3b80d8
Bob Wilson pointed out the unnecessary checks that had been committed to the
instruction check predicates. The check was meant to ensure that the check was
not accidentally applied to non-ARM instructions. This is better served as an
assertion rather than a condition check.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224825 91177308-0d34-0410-b5e6-96231b3b80d8
.set directives may be overridden by other .set directives as well as
label definitions.
This fixes PR22019.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224811 91177308-0d34-0410-b5e6-96231b3b80d8
Correct the line information generation for preprocessed assembly. Although we
tracked the source information for the macro instantiation, we failed to account
for the fact that we were instantiating a macro, which is populated into a new
buffer and that the line information would be relative to the definition rather
than the actual instantiation location. This could cause the line number
associated with the statement to be very high due to wrapping of the difference
calculated for the preprocessor line information emitted into the stream.
Properly calculate the line for the macro instantiation, referencing the line
where the macro is actually used as GCC/gas do.
The test case uses x86, though the same problem exists on any other target using
the LLVM IAS.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224810 91177308-0d34-0410-b5e6-96231b3b80d8
This removes a hardcoded list of instructions in the CodeEmitter. Eventually I intend to remove the predicates on the affected instructions since in any given mode two of them are valid if we supported addr32/addr16 prefixes in the assembler.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224809 91177308-0d34-0410-b5e6-96231b3b80d8
This function constructs the main liverange by merging all subranges if
subregister liveness tracking is available. This should be slightly
faster to compute instead of performing the liveness calculation again
for the main range. More importantly it avoids cases where the main
liverange would cover positions where no subrange was live. These cases
happened for partial definitions where the actual defined part was dead
and only the undefined parts used later.
The register coalescing requires that every part covered by the main
live range has at least one subrange live.
I also expect this function to become usefull later for places where the
subranges are modified in a way that it is hard to correctly fix the
main liverange in the machine scheduler, we can simply reconstruct it
from subranges then.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224806 91177308-0d34-0410-b5e6-96231b3b80d8
Without a reference the code did not remember when moving the iterators
of the subranges/registerunit ranges forward and instead would scan from
the beginning again at the next position.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224803 91177308-0d34-0410-b5e6-96231b3b80d8
Patch by Ramkumar Ramachandra <artagnon@gmail.com>.
Also remove Llvm_executionengine.get_pointer_to_global, as it
is actually deprecated and didn't appear in a stable release.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224801 91177308-0d34-0410-b5e6-96231b3b80d8
within a partition of an alloca in SROA.
This reflects the fact that the organization of the slices isn't really
ideal for analysis, but is the naive way in which the slices are
available while we're processing them in the core partitioning
algorithm.
It is possible we could improve matters, and I've left a FIXME with
one of my ideas for how to do this, but it is a lot of work, the benefit
is somewhat minor, and it isn't clear that it would be strictly better.
=/ Not really satisfying, but I'm out of really good ideas.
This also improves one place where the debug logging failed to mark some
split partitions. Now we log in one place, slightly later, and with
accurate information about whether the slice is split by the partition
being rewritten.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224800 91177308-0d34-0410-b5e6-96231b3b80d8
operate in terms of the new Partition class, and generally have a more
clear set of arguments. No functionality changed.
The most notable improvements here are consistently using the
terminology of 'partition' for a collection of slices that will be
rewritten together and 'slice' for a region of an alloca that is used by
a particular instruction.
This also makes it more clear that the split things are actually slices
as well, just ones that will be split by the proposed partition.
This doesn't yet address the confusing aspects of the partition's
interface where slices that will be split by the partition and start
prior to the partition are accesssed via Partition::splitSlices() while
the core range of slices exposed by a Partition includes both unsplit
slices and slices which will be split by the end, but started within the
offset range of the partition. This is particularly hard to address
because the algorithm which computes partitions quite literally doesn't
know which slices these will end up being until too late. I'm looking at
whether I can fix that or not, but I'm not optimistic. I'll update the
comments and/or names to further explain this either way. I've also
added one FIXME in this patch relating to this confusion so that I don't
forget about it.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224798 91177308-0d34-0410-b5e6-96231b3b80d8
On non-Darwin PPC64, the TOC reload needs to come directly after the bctrl
instruction (for indirect calls) because the 'bctrl/ld 2, 40(1)' instruction
sequence is interpreted by the unwinding code in libgcc. To make sure these
occur as a pair, as with other pairings interpreted by the linker, fuse the two
instructions into one instruction (for code generation only).
In the future, we might wish to do this by emitting CFI directives instead,
but this solution is simpler, and mirrors what GCC does. Additional discussion
on this point is contained in the PR.
Fixes PR22015.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224788 91177308-0d34-0410-b5e6-96231b3b80d8
a size and alignment. Several assertions in DwarfDebug rely on all variable
types to report back a size, or to be derived from a type with a size.
Tested in CFE.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224780 91177308-0d34-0410-b5e6-96231b3b80d8
Right now in DAG Combine check the validity of the returned type
only when -debug is given on the command line. However usually
the test cases in the validation does not use -debug.
An Assert build should always check this.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224779 91177308-0d34-0410-b5e6-96231b3b80d8
GlobalAlias handling used to be after GlobalValue handling, which meant it was, in practice, dead code. r220165 moved GlobalAlias handling to be before GlobalValue handling, but also moved it to be before the max depth check, causing an assert due to a recursion depth limit violation.
This moves GlobalAlias handling forward to where it's safe, and changes the GlobalValue handling to only look at GlobalObjects.
Differential Revision: http://reviews.llvm.org/D6758
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224765 91177308-0d34-0410-b5e6-96231b3b80d8
It is tempting to mark the fixed stack slot used to store the return address as
immutable when lowering @llvm.returnaddress(i32 0). Unfortunately, within the
function, it is not completely immutable: it is written during the function
prologue. When using post-RA instruction scheduling, the prologue instructions
are available for scheduling, and we're not free to interchange the order of a
particular store in the prologue with loads from that stack location.
Fixes PR21976.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224761 91177308-0d34-0410-b5e6-96231b3b80d8
In r224033, in moving the signed power-of-2 division expansion into
BuildSDIVPow2, I accidentally made it possible to attempt the lowering for a
64-bit division on PPC32. This later asserts.
Fixes PR21928.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224758 91177308-0d34-0410-b5e6-96231b3b80d8
- Fix the case where more than 1 common instructions derived from the same
operand cannot be sunk. When a pair of value has more than 1 derived values
in both branches, only 1 derived value could be sunk.
- Replace BB1 -> (BB2, PN) map with joint value map, i.e.
map of (BB1, BB2) -> PN, which is more accurate to track common ops.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224757 91177308-0d34-0410-b5e6-96231b3b80d8
A cast that was introduced in r209007 was accidentally left in after the changes made to GlobalAlias rules in r210062. This crashes if the aliasee is a now-leggal ConstantExpr.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224756 91177308-0d34-0410-b5e6-96231b3b80d8
r223862/r224203 tried to also combine base-updating load/stores.
There was a mistake there: the alignment was added as is as an operand to
the ARMISD::VLD/VST node. However, the VLD/VST selection logic doesn't care
about less-than-standard alignment attributes.
For example, no matter the alignment of a v2i64 load (say 1), SelectVLD picks
VLD1q64 (because of the memory type). But VLD1q64 ("vld1.64 {dXX, dYY}") is
8-aligned, per ARMARMv7a 3.2.1.
For the 1-aligned load, what we really want is VLD1q8.
This commit introduces bitcasts if necessary, and changes the vld/vst type to
one whose standard alignment matches the original load/store alignment.
Differential Revision: http://reviews.llvm.org/D6759
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@224754 91177308-0d34-0410-b5e6-96231b3b80d8
