galileo: Correct README.md to explain how to verify boot with UART

This patch revises README.md to mention the UART support introduced by
earlier patches in the section about verifying that Contiki is
running.  It also revises the serial console setup instructions to
focus on the more thoroughly tested option.
This commit is contained in:
Michael LeMay 2015-07-24 07:50:59 -07:00 committed by Jesus Sanchez-Palencia
parent bdcf58033a
commit 06e25c487a

View File

@ -96,11 +96,11 @@ $ cp platform/galileo/bsp/grub/bin/grub.efi /mnt/sdcard
### Connect to the console output
Connect the serial cable to your computer as showed in [2].
Connect the serial cable to your computer as shown in [2].
Choose one terminal emulator such as screen, putty or minicom. Make sure you
use keyboard SCO mode (on putty that option is at Terminal -> Keyboard, on
the left menu). Connect to /dev/ttyUSB0, use 115200 speed.
Choose a terminal emulator such as PuTTY. Make sure you use the SCO keyboard
mode (on PuTTY that option is at Terminal -> Keyboard, on the left menu).
Connect to the appropriate serial port using a baud rate of 115200.
### Boot Contiki Image
@ -118,15 +118,19 @@ $ fs0:
$ grub.efi
```
You'll reach de grub shell. Now run the following commands to boot Contiki
You'll reach the grub shell. Now run the following commands to boot Contiki
image:
```
$ multiboot /hello-world.galileo
$ boot
```
For now, we lack of UART support so you won't see any output. However, you can
use JTAG (see next section) to verify that the Contiki is running.
This should boot the Contiki image, resulted in the following messages being
sent to the serial console:
```
Starting Contiki
Hello World
```
Debugging
---------