galileo: Convert README for examples into README.md

This patch renames and reformats examples/galileo/README to use
Markdown.
This commit is contained in:
Michael LeMay 2016-01-06 17:17:25 -08:00
parent c815fa4511
commit c9bffe6d5a

View File

@ -1,5 +1,5 @@
Galileo Specific Examples
=======================
=========================
This directory contains galileo-specific example applications to illustrate
how to use galileo APIs.
@ -7,14 +7,15 @@ how to use galileo APIs.
In order to build a application, you should set the EXAMPLE environment
variable to the name of the application you want to build. For instance, if
you want to build gpio-output application, run the following command:
```
$ make TARGET=galileo EXAMPLE=gpio-output
```
============
= GPIO =
============
GPIO
----
GPIO Output
===========
### GPIO Output
This application shows how to use the GPIO driver APIs to manipulate output
pins. This application sets the GPIO 4 pin as output pin and toggles its
@ -23,16 +24,14 @@ state at every half second.
For a visual effect, you should wire shield pin IO1 to a led in a protoboard.
Once the application is running, you should see a blinking LED.
GPIO Input
==========
### GPIO Input
This application shows how to use the GPIO driver APIs to manipulate input
pins. This application uses default galileo pinmux initialization and sets
the GPIO 5 (IO2) as output pin and GPIO 6 (IO3) as input. It toggles the
output pin state at every half second and checks the value on input pin.
GPIO Interrupt
==============
### GPIO Interrupt
This application shows how to use the GPIO driver APIs to manipulate interrupt
pins. This application uses default galileo pinmux initialization and sets
@ -41,12 +40,11 @@ output pin stat at every half second in order to emulate an interrupt. This
triggers an interrupt and the application callback is called. You can confirm
that though the UART output.
=======
= I2C =
=======
I2C
---
### I2C LSM9DS0
I2C LSM9DS0
===========
This application shows how to use I2C driver APIs to configure I2C Master
controller and communicate with LSM9DS0 sensor. At every 5 seconds, the
application reads the "who am I" register from gyroscope sensor and prints if
@ -65,9 +63,8 @@ The wiring setup is as follows (left column from Galileo and right column from L
- SDA and SDA
- SCL and SCL
==============
= References =
==============
References
----------
[1] http://www.st.com/st-web-ui/static/active/en/resource/technical/document/datasheet/DM00087365.pdf