include $(CONTIKI)/cpu/x86/Makefile.x86_common CONTIKI_CPU_DIRS += drivers/legacy_pc drivers/quarkX1000 init/legacy_pc CONTIKI_SOURCEFILES += bootstrap_quarkX1000.S rtc.c pit.c pic.c irq.c nmi.c pci.c uart-16x50.c uart.c gpio.c i2c.c eth.c shared-isr.c CFLAGS += -m32 -march=i586 -mtune=i586 LDFLAGS += -m32 -Xlinker -T -Xlinker $(CONTIKI)/cpu/x86/quarkX1000.ld ASFLAGS += --32 -march=i586 -mtune=i586 ### UEFI support UEFI_DIR = $(CONTIKI_CPU)/uefi ifndef EN_UEFI # Include a Makefile generated by the build_uefi.sh script, if available. # If that script was not run, then UEFI support will not be built. -include $(UEFI_DIR)/Makefile.uefi endif ifeq ($(EN_UEFI),1) EDK2_DIR = $(UEFI_DIR)/edk2 GEN_FW = $(EDK2_DIR)/BaseTools/Source/C/bin/GenFw CONTIKI_CPU_DIRS += uefi CONTIKI_SOURCEFILES += bootstrap_uefi.c CFLAGS += -I$(EDK2_DIR)/MdePkg/Include -I$(EDK2_DIR)/MdePkg/Include/Ia32 else $(info Note: UEFI support is disabled.) $(info To enable UEFI support, run $(CONTIKI_CPU)/uefi/build_uefi.sh prior) $(info to building Contiki.) endif