contiki/cpu/cc253x/dev/uart1.c
George Oikonomou ad256e5014 New platform: TI cc2530 Development Kit
This commits adds support for TI's SmartRF05 Eval. Board with cc2530 EMs
Some initial support for cc2531 USB dongles
2012-03-23 14:41:07 +00:00

75 lines
1.7 KiB
C

/**
* \file
*
* uart1 write routines
*
* \author
*
* Anthony "Asterisk" Ambuehl
*
*/
#include <stdlib.h>
#include <string.h>
#include "cc253x.h"
#include "dev/uart1.h"
#if UART1_ENABLE
/*---------------------------------------------------------------------------*/
/* UART1 initialization */
void
uart1_init()
{
#ifdef UART1_ALTERNATIVE_1
PERCFG &= ~PERCFG_U1CFG; /*alternative port 1 = P0.5-2*/
#ifdef UART1_RTSCTS
P0SEL |= 0x3C; /*peripheral select for TX and RX, RTS, CTS*/
#else
P0SEL |= 0x30; /*peripheral select for TX and RX*/
P0 &= ~0x08; /*RTS down*/
#endif
P0DIR |= 0x18; /*RTS, TX out*/
P0DIR &= ~0x24; /*CTS, RX in*/
#else
PERCFG |= PERCFG_U1CFG; /*alternative port 2 = P1.7-4*/
#ifdef UART1_RTSCTS
P1SEL |= 0xF0; /*peripheral select for TX and RX*/
#else
P1SEL |= 0xC0; /*peripheral select for TX and RX*/
P1 &= ~0x20; /*RTS down*/
#endif
P1DIR |= 0x60; /*RTS, TX out*/
P1DIR &= ~0x90; /*CTS, RX in*/
#endif
#if UART_ONE_CONF_HIGH_SPEED
UART_SET_SPEED(1, UART_460_M, UART_460_E);
#else
UART_SET_SPEED(1, UART_115_M, UART_115_E);
#endif
#ifdef UART1_RTSCTS
U1UCR = 0x42; /*defaults: 8N1, RTS/CTS, high stop bit*/
#else
U1UCR = 0x02; /*defaults: 8N1, no flow control, high stop bit*/
#endif
U1CSR = UCSR_MODE; /* UART mode */
U1UCR = 0x80; /* Flush */
UART1_RX_INT(1);
U0DBUF = 0;
}
/*---------------------------------------------------------------------------*/
/* Write one byte over the UART. */
void
uart1_writeb(uint8_t byte)
{
UTX1IF = 0;
U1DBUF = byte;
while(!UTX1IF); /* Wait until byte has been transmitted. */
UTX1IF = 0;
}
/*---------------------------------------------------------------------------*/
#endif