|
…
|
||
|---|---|---|
| .. | ||
| example-sky-websense.csc | ||
| Makefile | ||
| Makefile.target | ||
| project-conf.h | ||
| README.md | ||
| websense-remote.c | ||
| wget.c | ||
| wget.h | ||
| z1-websense.c | ||
Z1 websense
This example features a simple webserver running on top of the IPv6 contiki stack on Zolertia Z1 motes to provide sensor values, and with a RPL border router to bridge the sensor network to Internet.
To test the example in COOJA under Linux
-
Start COOJA and load the simulation "example-z1-websense.csc"
make TARGET=cooja example-z1-websense.csc
-
Connect to the COOJA simulation using tunslip6:
make connect-router-cooja
-
You should now be able to browse to the nodes using your web browser: Router: http://[aaaa::0212:7401:0001:0101]/ Node 2: http://[aaaa::0212:7402:0002:0202]/
To run the example on real nodes under Linux
-
Program the nodes with the websense application
make TARGET=z1 z1-websense.upload
-
Disconnect the nodes and program one node with the RPL border router
cd ../rpl-border-router && make TARGET=z1 border-router.upload
-
Connect to the border router using tunslip6:
make connect-router
-
Reboot the router and note the router IP address
-
You should now be able to browse to your router node using your web browser: http://[]/. On this page you should see a list of all accessible nodes with their IP adresses.