{\rtf1\ansi\ansicpg1252\deff0\deflang1033{\fonttbl{\f0\fnil\fcharset0 Courier New;}{\f1\fswiss\fcharset0 Arial;}} {\*\generator Msftedit 5.41.15.1507;}\viewkind4\uc1\pard\f0\fs20 =-------------------------------------=\par =-> Freeze's F-8 ROM A PPG release <-=\par =-------------------------------------=\par \par The Freeze's F-8 ROM is a modified F-8\par rom that has several added features.\par \par -Old Monitor Reset\par -Step and Trace modes\par -Disassembly with ASCII\par -Disassembly with Binary in #Mode\par -Better sounding bell!\par \par These advanced features make Monitor\par programming and Cracking much easier.\par \par There are two ways you can use this\par program. Either load it into the RAM\par Card using the FREEZE.INSTALL program.\par The other way is to burn it onto a\par 2716 EPROM (Schematics later).\par \par The only thing that really need an\par explanation is the disassembly. In the\par disassembly, it displays the ASCII\par value of the byte to the right. The\par binary numbers on the far right are\par displayed when an instruction on the\par accumulator in immediate mode is\par encountered.\par \par 2716 Schematics\par ===============\par \par I would suggest that you do these\par modifications to a socket rather than\par directly to the chip...\par \par First, cut off pins 21 and 18.\par Connect pins 12 and 18\par Connect pins 21 and 24\par \par ---------------------------------------\par \f1\par }