From a49046abebcc504dade98f514d7ea8c544bd41d5 Mon Sep 17 00:00:00 2001 From: Eric Helgeson Date: Mon, 9 May 2022 16:18:34 -0500 Subject: [PATCH] Updated BlueSCSI 1.1 Desktop Assembly (markdown) --- BlueSCSI-1.1-Desktop-Assembly.md | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) diff --git a/BlueSCSI-1.1-Desktop-Assembly.md b/BlueSCSI-1.1-Desktop-Assembly.md index 3e897c2..73c4af5 100644 --- a/BlueSCSI-1.1-Desktop-Assembly.md +++ b/BlueSCSI-1.1-Desktop-Assembly.md @@ -30,7 +30,9 @@ None yet 2. Solder the 2 diode to the board, ensure it is as flush with the PCB as possible. Trim the excess legs -3. Solder on the resistor nets ensuring correct placement and orientation +3. Solder on the resistor nets ensuring correct placement and orientation. + +* Note: Pin 1 on the resistor nets is denoted with a dot. That must line up with the square silk screen on the board denoting pin 1. 4. Solder on the Termination Jumpers & place the jumpers on to enable Termination 5. Solder on the berg connector. Only needed if your machine does not supply enough power via the SCSI bus, but recommended to solder on if you have the connector