mirror of
https://github.com/elliotnunn/NetBoot.git
synced 2024-09-08 00:54:50 +00:00
55 lines
1.7 KiB
Plaintext
55 lines
1.7 KiB
Plaintext
This chapter describes the Motorola srecord output module which can be
|
|
selected with the @option{-Fsrec} option.
|
|
|
|
@section Legal
|
|
|
|
This module is written in 2015 by Joseph Zatarski and
|
|
is covered by the vasm copyright without modifications.
|
|
|
|
@section Additional options for this module
|
|
|
|
@table @option
|
|
@item -s19
|
|
Writes S1 data records and S9 trailers with 16-bit addresses.
|
|
@item -s28
|
|
Writes S2 data records and S8 trailers with 24-bit addresses.
|
|
@item -s37
|
|
Writes S3 data records and S7 trailers with 32-bit addresses.
|
|
This is the default setting.
|
|
@item -exec[=<symbol>]
|
|
Use the given symbol <symbol> as entry point of the program.
|
|
This start address will be written into the trailer record,
|
|
which is otherwise zero.
|
|
When the symbol assignment is omitted, then the default symbol
|
|
@code{start} will be used.
|
|
@end table
|
|
|
|
@section General
|
|
|
|
This output module outputs the contents of all sections in Motorola srecord
|
|
format, which is a simple ASCII output of hexadecimal digits. Each record
|
|
starts with '@code{S}' and a one-digit ID. It is followed by the data
|
|
and terminated by a checksum and a newline character.
|
|
Every section starts with a new header record.
|
|
|
|
@section Known Problems
|
|
|
|
Some known problems of this module at the moment:
|
|
|
|
@itemize @minus
|
|
|
|
@item A new header is written for every new section. This may cause
|
|
compatibility issues.
|
|
|
|
@end itemize
|
|
|
|
@section Error Messages
|
|
|
|
This module has the following error messages:
|
|
|
|
@itemize @minus
|
|
@item 3007: undefined symbol <%s>
|
|
@item 3010: section <%s>: alignment padding (%lu) not a multiple of %lu at 0x%llx
|
|
@item 3012: address 0x%llx out of range for selected format
|
|
@end itemize
|