PCI config read fails should return all 1 bits.
All unused registers in an existing PCI device should return 0.
Because that's what my Power Mac 8600 returns when I run my Open Firmware lspci command.
Any bus/device/function that doesn't exist returns FF and won't be listed by lspci.
Any registers that are unused will show as 00 in the lspci output.
Make grackle log bus:device.function @register.size in all cases.
- Allow changing integer variables. Previously they could not be changed.
- Allow changing string variables. Previously they could only be changed if their length increased.
- printenv had a bug with strings longer than 32 characters.
- printenv now translates carriage return (used in nvramrc) as endl (which should perform carriage return and linefeed)
- For integers, setenv assumes decimal number input but if that fails it will try hex conversion. 0x prefix for hex numbers is optional unless the number only has digits 0 - 9.
- setenv converts linefeed to carriage return for string variables. nvramrc requires this for proper editing in Open Firmware.
- Added Open Firmware 2.4 nvram field names to OfNvramHdr comments.
The expansion rom base register indicates the size of the expansion rom by the number of bits that remain zero after code attempts to set them all to 1. For example, a result of fffe0000 means 128K. The 11 least significant bits are ignored in the size calculation, which means the minimum rom size is indicated by fffff800 = 2K.
Handle the case where an expansion rom file might not have a size that is a multiple of 2 or is not greater than 2K.
Bytes between the end of the file and the end of the calculated rom size are set to 0xff.
Don't always return 0 when reading it. The status register contains some bits that Open Firmware uses to set some properties.
A PCI device can set a default status register value to set those bits.
this->status = 0x02B0; // 0000 0 01 0 1 0 1 1 0000 Capabilities List, 66 MHz, Fast Back-to-Back, DevSel Speed: Medium
For invalid or unsupported PCI accesses, do the following:
- log a device's full pci address using pciutils setpci command format bb:dd.f @rr.s (bus:device:function @register+offset.size).
- report as read or write access.
- log value for writes.
- bus, device, function, and register values cannot be determined from Invalid IDSEL values so they will output as ??.
- for invalid IDSEL values, report the entire value of the config_addr.
- for valid IDSEL values, the bus number cannot be determined since IDSEL only specifies device number. It's probably bus 00 but we'll show ?? to indicate an IDSEL type access.
Add missing config type read access logging for chaos.
