PAR: Place And Route Diamond (64-bit) 3.12.0.240.2.
Copyright (c) 1991-1994 by NeoCAD Inc. All rights reserved.
Copyright (c) 1995 AT&T Corp. All rights reserved.
Copyright (c) 1995-2001 Lucent Technologies Inc. All rights reserved.
Copyright (c) 2001 Agere Systems All rights reserved.
Copyright (c) 2002-2020 Lattice Semiconductor Corporation, All rights reserved.
Mon Aug 16 21:32:27 2021
C:/lscc/diamond/3.12/ispfpga\bin\nt64\par -f RAM2GS_LCMXO256C_impl1.p2t
RAM2GS_LCMXO256C_impl1_map.ncd RAM2GS_LCMXO256C_impl1.dir
RAM2GS_LCMXO256C_impl1.prf -gui -msgset
C:/Users/Dog/Documents/GitHub/RAM2GS/CPLD/LCMXO/LCMXO256C/promote.xml
Preference file: RAM2GS_LCMXO256C_impl1.prf.
Cost Table Summary
Level/ Number Worst Timing Worst Timing Run NCD
Cost [ncd] Unrouted Slack Score Slack(hold) Score(hold) Time Status
---------- -------- ----- ------ ----------- ----------- ---- ------
5_1 * 0 2.023 0 0.339 0 07 Completed
* : Design saved.
Total (real) run time for 1-seed: 7 secs
par done!
Note: user must run 'Trace' for timing closure signoff.
Lattice Place and Route Report for Design "RAM2GS_LCMXO256C_impl1_map.ncd"
Mon Aug 16 21:32:27 2021
Best Par Run
PAR: Place And Route Diamond (64-bit) 3.12.0.240.2.
Command Line: par -w -l 5 -i 6 -t 1 -c 0 -e 0 -gui -msgset C:/Users/Dog/Documents/GitHub/RAM2GS/CPLD/LCMXO/LCMXO256C/promote.xml -exp parUseNBR=1:parCDP=0:parCDR=0:parPathBased=OFF:parASE=1 RAM2GS_LCMXO256C_impl1_map.ncd RAM2GS_LCMXO256C_impl1.dir/5_1.ncd RAM2GS_LCMXO256C_impl1.prf
Preference file: RAM2GS_LCMXO256C_impl1.prf.
Placement level-cost: 5-1.
Routing Iterations: 6
Loading design for application par from file RAM2GS_LCMXO256C_impl1_map.ncd.
Design name: RAM2GS
NCD version: 3.3
Vendor: LATTICE
Device: LCMXO256C
Package: TQFP100
Performance: 3
Loading device for application par from file 'mj5g10x6.nph' in environment: C:/lscc/diamond/3.12/ispfpga.
Package Status: Final Version 1.19.
Performance Hardware Data Status: Version 1.124.
License checked out.
Ignore Preference Error(s): True
Device utilization summary:
PIO (prelim) 67/79 84% used
67/78 85% bonded
SLICE 65/128 50% used
Number of Signals: 252
Number of Connections: 618
Pin Constraint Summary:
67 out of 67 pins locked (100% locked).
The following 4 signals are selected to use the primary clock routing resources:
RCLK_c (driver: RCLK, clk load #: 39)
PHI2_c (driver: PHI2, clk load #: 13)
nCCAS_c (driver: nCCAS, clk load #: 4)
nCRAS_c (driver: nCRAS, clk load #: 7)
No signal is selected as secondary clock.
No signal is selected as Global Set/Reset.
Starting Placer Phase 0.
........
Finished Placer Phase 0. REAL time: 0 secs
Starting Placer Phase 1.
...............
Placer score = 586066.
Finished Placer Phase 1. REAL time: 6 secs
Starting Placer Phase 2.
.
Placer score = 584668
Finished Placer Phase 2. REAL time: 6 secs
Clock Report
Global Clock Resources:
CLK_PIN : 1 out of 4 (25%)
General PIO: 3 out of 80 (3%)
Global Clocks:
PRIMARY "RCLK_c" from comp "RCLK" on CLK_PIN site "86 (PT4A)", clk load = 39
PRIMARY "PHI2_c" from comp "PHI2" on PIO site "39 (PB3D)", clk load = 13
PRIMARY "nCCAS_c" from comp "nCCAS" on PIO site "27 (PL9B)", clk load = 4
PRIMARY "nCRAS_c" from comp "nCRAS" on PIO site "43 (PB4A)", clk load = 7
PRIMARY : 4 out of 4 (100%)
SECONDARY: 0 out of 4 (0%)
I/O Usage Summary (final):
67 out of 79 (84.8%) PIO sites used.
67 out of 78 (85.9%) bonded PIO sites used.
Number of PIO comps: 67; differential: 0.
Number of Vref pins used: 0.
I/O Bank Usage Summary:
+----------+----------------+------------+------------+------------+
| I/O Bank | Usage | Bank Vccio | Bank Vref1 | Bank Vref2 |
+----------+----------------+------------+------------+------------+
| 0 | 36 / 41 ( 87%) | 3.3V | - | - |
| 1 | 31 / 37 ( 83%) | 3.3V | - | - |
+----------+----------------+------------+------------+------------+
Total placer CPU time: 6 secs
Dumping design to file RAM2GS_LCMXO256C_impl1.dir/5_1.ncd.
0 connections routed; 618 unrouted.
Starting router resource preassignment
WARNING - par: The driver of primary clock net PHI2_c is not placed on one of the PIO sites dedicated for primary clocks. This primary clock will be routed to a H-spine through general routing resource and may suffer from excessive delay or skew.
WARNING - par: The driver of primary clock net nCRAS_c is not placed on one of the PIO sites dedicated for primary clocks. This primary clock will be routed to a H-spine through general routing resource and may suffer from excessive delay or skew.
WARNING - par: The driver of primary clock net nCCAS_c is not placed on one of the PIO sites dedicated for primary clocks. This primary clock will be routed to a H-spine through general routing resource and may suffer from excessive delay or skew.
Completed router resource preassignment. Real time: 6 secs
Start NBR router at 21:32:33 08/16/21
*****************************************************************
Info: NBR allows conflicts(one node used by more than one signal)
in the earlier iterations. In each iteration, it tries to
solve the conflicts while keeping the critical connections
routed as short as possible. The routing process is said to
be completed when no conflicts exist and all connections
are routed.
Note: NBR uses a different method to calculate timing slacks. The
worst slack and total negative slack may not be the same as
that in TRCE report. You should always run TRCE to verify
your design.
*****************************************************************
Start NBR special constraint process at 21:32:33 08/16/21
Start NBR section for initial routing at 21:32:33 08/16/21
Level 1, iteration 1
0(0.00%) conflict; 535(86.57%) untouched conns; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.084ns/0.000ns; real time: 6 secs
Level 2, iteration 1
0(0.00%) conflict; 535(86.57%) untouched conns; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.084ns/0.000ns; real time: 6 secs
Level 3, iteration 1
0(0.00%) conflict; 509(82.36%) untouched conns; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.038ns/0.000ns; real time: 6 secs
Level 4, iteration 1
23(0.19%) conflicts; 0(0.00%) untouched conn; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.023ns/0.000ns; real time: 6 secs
Info: Initial congestion level at 75% usage is 0
Info: Initial congestion area at 75% usage is 0 (0.00%)
Start NBR section for normal routing at 21:32:33 08/16/21
Level 1, iteration 1
0(0.00%) conflict; 24(3.88%) untouched conns; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.023ns/0.000ns; real time: 6 secs
Level 4, iteration 1
8(0.07%) conflicts; 0(0.00%) untouched conn; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.023ns/0.000ns; real time: 6 secs
Level 4, iteration 2
4(0.03%) conflicts; 0(0.00%) untouched conn; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.023ns/0.000ns; real time: 6 secs
Level 4, iteration 3
0(0.00%) conflict; 0(0.00%) untouched conn; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.023ns/0.000ns; real time: 6 secs
Start NBR section for setup/hold timing optimization with effort level 3 at 21:32:33 08/16/21
Start NBR section for re-routing at 21:32:33 08/16/21
Level 4, iteration 1
0(0.00%) conflict; 0(0.00%) untouched conn; 0 (nbr) score;
Estimated worst slack/total negative slack<setup>: 2.023ns/0.000ns; real time: 6 secs
Start NBR section for post-routing at 21:32:33 08/16/21
End NBR router with 0 unrouted connection
NBR Summary
-----------
Number of unrouted connections : 0 (0.00%)
Number of connections with timing violations : 0 (0.00%)
Estimated worst slack<setup> : 2.023ns
Timing score<setup> : 0
-----------
Notes: The timing info is calculated for SETUP only and all PAR_ADJs are ignored.
Total CPU time 6 secs
Total REAL time: 7 secs
Completely routed.
End of route. 618 routed (100.00%); 0 unrouted.
Hold time timing score: 0, hold timing errors: 0
Timing score: 0
Dumping design to file RAM2GS_LCMXO256C_impl1.dir/5_1.ncd.
All signals are completely routed.
PAR_SUMMARY::Run status = Completed
PAR_SUMMARY::Number of unrouted conns = 0
PAR_SUMMARY::Worst slack<setup/<ns>> = 2.023
PAR_SUMMARY::Timing score<setup/<ns>> = 0.000
PAR_SUMMARY::Worst slack<hold /<ns>> = 0.339
PAR_SUMMARY::Timing score<hold /<ns>> = 0.000
PAR_SUMMARY::Number of errors = 0
Total CPU time to completion: 6 secs
Total REAL time to completion: 7 secs
par done!
Note: user must run 'Trace' for timing closure signoff.
Copyright (c) 1991-1994 by NeoCAD Inc. All rights reserved.
Copyright (c) 1995 AT&T Corp. All rights reserved.
Copyright (c) 1995-2001 Lucent Technologies Inc. All rights reserved.
Copyright (c) 2001 Agere Systems All rights reserved.
Copyright (c) 2002-2020 Lattice Semiconductor Corporation, All rights reserved.