README.md : added info about the Push switch usage
This commit is contained in:
parent
2006182094
commit
0df11718b7
|
@ -189,7 +189,14 @@ Troubleshooting:
|
|||
the pin 1 location). Note that the 16V8 GALs have to be inserted close to the ZIF lever - see the title image above.
|
||||
|
||||
* ensure the VPP is set correctly on the MT3608 module. Ensure you've gone through all the calibration steps (commands: 's' then 'b' and 'm') and calibration is correct. See the Setup section.
|
||||
|
||||
|
||||
- what is the Push switch used for? When do I use it?
|
||||
* Normally, the button should be in the Off position (LED is not lit). Also when insering
|
||||
the GAL chip or when removing the GAL chip from the ZIF socket the switch should be Off.
|
||||
* When using Afterburner's PC app with commands to Identify (i), Read or Verify (r, v) or
|
||||
Write (w) the switch has to be On (LED is lit).
|
||||
* So in general: insert the GAL when the switch is Off, then turn the switch On, run the
|
||||
PC app command. When finished turn the switch Off, remove the GAL chip from the socket.
|
||||
|
||||
- afterburner reports it can not connect to /dev/ttyUSB0, permission denied
|
||||
|
||||
|
|
Loading…
Reference in New Issue