- Clean up diode positioning and numbering
- Remove 3D models for devices that are not normally fitted
- clean up labeling
- update README files to match PCBs.
For better matching of current limit resistors to LEDs, the resistors are moved
to the keyboard matrix PCB, where they can be tuned for maximum brightness (at
100% duty cycle). This allows consistent keyboard brightness when a single
interface PCB is swapped between keyboard matrices.
- swap numbering of row select protection diodes for cleaner PCB labeling
- clarify labeling on GPIO pins on the MCU
- bump rev to 2.4 to indicate work in progress. Release will be 2.5.
- Fix wrong direction DIP switch diodes
- Add buffers to permit ISP lines to also be used as output and LED drivers
- Allow 3 keyboard LEDs and 3 host outputs (RESET, CLEAR, BREAK, LOCAL, etc.).
- Outputs 1 and 3 are general purpose (can be open drain or driven). Output 2
is open collector (with optional on-board pullup).
- Add apple 2 mounting slots (and stretch PCB to accommodate slots
- Add pass-through holes in aligners for OSI keyboard spacers
- Move 'ESC' key next to '1' key
- Add TAB key next to Q key
- remove 'here is' and finalize "helper" keys along left side of keyboard
- move legends off of PCB traces
- update to release 1.3
- Add OSI-compatible mounting holes.
- Adjust keyboard and aligner holes to make room for the OSI mounting holes
- Change "Universal Keyboard" to "Unified Keyboard" in the design files.
