diff --git a/README-veserver.md b/README-veserver.md
index 50dba77..e152814 100644
--- a/README-veserver.md
+++ b/README-veserver.md
@@ -14,6 +14,11 @@ place of the ADTPro server for this purpose.  VEServer is a much smaller and
 simpler program, so it is easier to modify and better suited to being run as
 a system service.
 
+VEServer can also support RS232 serial connections, in which case ADTPro's
+`VSDRIVE.SYSTEM` should be used on the Apple II rather than `VEDRIVE.SYSTEM`.
+The default mode of operation is to use ethernet.  See the Command Line
+Options section below for information on how to switch to serial mode.
+
 ## Principle of Operation
 
 VEServer uses IPv6 and listens on UDP port 6502 for incoming datagrams from
@@ -34,12 +39,19 @@ ProDOS 2.5 please specify the `--prodos25` flag to use the new format.
 
 ## Command Line Options
 
-There are only a few options:
+VEServer accepts the following command line options; each option has a short
+form and a verbose form:
 
  - `-h`, `--help` - Display brief usage information.
  - `-p`, `--prodos25` - Use new ProDOS 2.5 date/time format (see above.)
- - `-1 FNAME`, `--disk1=FNAME` - Specify filename for disk 1 image. 
- - `-2 FNAME`, `--disk2=FNAME` - Specify filename for disk 1 image. 
+ - `-1 FNAME`, `--disk1=FNAME` - Specify filename for disk 1 image.
+ - `-2 FNAME`, `--disk2=FNAME` - Specify filename for disk 1 image.
+ - '-s', '--serial' - Use RS232 serial rather than Ethernet.
+ - '-b nnnnn', '--baud=nnnnn' - Specify baud rate when using serial connection.
+
+If the `--disk1=FNAME` or `--disk2=FNAME` options are not specified, VEServer
+will fall back to using the default values hard coded at the top of the
+Python script.
 
 ## Running in a Shell
 
@@ -75,3 +87,28 @@ following command:
 Rather than using colour to indicate reads and writes the letter 'R' or 'W' is
 shown before the block number in the log.
 
+## Working with Multiple Apple II Clients (Advanced)
+
+If you use `VEDRIVE.SYSTEM` on more than one Apple II machine, it is sometimes
+convenient to be able to use different disk images on each machine.  VEServer
+offers a way to do this.
+
+Suppose the disk1 filename is set to `virtual-1.po` and the disk2 filename is
+set to `virtual-2.po` (either using the `--disk1=FNAME` / `--disk2=FNAME`
+command line parameters, or using the hard-coded default.)  Further, suppose
+the IP address of the Apple II client is 192.168.0.100.  In this case, when
+accessing drive 1, VEServer will first look for the file:
+
+ - `virtual-1-192.168.0.100.po`
+
+If this is found that file will be served.  If not found, VEServer will fall
+back to:
+
+ - `virtual-1.po`
+
+Similarly for drive 2, `virtual-2-192.168.0.100.po` will be used if it exists,
+or `virtual-2.po` otherwise.
+
+This mechanism allows you to serve different disk images for each client,
+allowing read/write access with no risk of data corruption due to simultaneous
+access.