contiki/examples/galileo/Makefile

TARGET=galileo

KNOWN_EXAMPLES = gpio-input gpio-output gpio-interrupt i2c-LSM9DS0 i2c-callbacks

ifneq ($(filter $(EXAMPLE),$(KNOWN_EXAMPLES)),)
  CONTIKI_PROJECT = $(EXAMPLE)
else
  CONTIKI_PROJECT = help
endif

all: $(CONTIKI_PROJECT)

CONTIKI = ../..
include $(CONTIKI)/Makefile.include

help:
	@echo -e "\nSet the variable EXAMPLE to one of the following Galileo-specific examples:"
	@for EXAMPLE in $(KNOWN_EXAMPLES); do echo $$EXAMPLE; done
galileo: Add I2C master example This patch adds an example application that shows how to use I2C driver APIs to communicate with LSM9DS0 sensor. At every 5 seconds, the application reads the "Who Am I" register from gyroscope sensor and prints if the register value matches the expected value. 2015-10-07 13:16:39 +00:00			`TARGET=galileo`

galileo: Add I2C callbacks example This patch adds an example for I2C callbacks that is very similar to the i2c-LSM9DS0 example except that it uses a PWM device that is built into the platform. 2016-01-07 01:25:55 +00:00			`KNOWN_EXAMPLES = gpio-input gpio-output gpio-interrupt i2c-LSM9DS0 i2c-callbacks`
galileo: Add GPIO output example This patch introduces an example application to demonstrate how to use GPIO driver APIs to manipulate output pins. The application sets the GPIO 4 pin as output pin and toggles its state at every half second. 2015-09-24 17:24:46 +00:00
			`ifneq ($(filter $(EXAMPLE),$(KNOWN_EXAMPLES)),)`
			`CONTIKI_PROJECT = $(EXAMPLE)`
			`else`
			`CONTIKI_PROJECT = help`
			`endif`

			`all: $(CONTIKI_PROJECT)`

			`CONTIKI = ../..`
			`include $(CONTIKI)/Makefile.include`

			`help:`
			`@echo -e "\nSet the variable EXAMPLE to one of the following Galileo-specific examples:"`
			`@for EXAMPLE in $(KNOWN_EXAMPLES); do echo $$EXAMPLE; done`