mirror of
https://github.com/oliverschmidt/contiki.git
synced 2024-08-29 13:29:09 +00:00
Remove the troublesome avr/dev/delay.* files. Add PLATFORM_NAME and combine the confusing *_REVISION defines into a single PLATFORM_TYPE |
||
---|---|---|
.. | ||
dev | ||
bridge-conf.h | ||
fakeuip.c | ||
Makefile | ||
README | ||
sicslow_ethernet.c | ||
sicslow_ethernet.h | ||
uip6-bridge-tap.c |
See siscslow_ethernet.c for information about translation between 802.15.4 and 802.3 addresses. Devices must have a proper EUI-64 address for this bridge to work. If the EUI-64 address of the devices cannot be changed and they are incompatible with the translation mechanism, you have to change the translation rules (they are defined in mac_createSicslowpanLongAddr() and mac_createEthernetAddr()). Usage example: run tapslip6 (source file are located in tools folder). ./tapslip6 -p 2001:db8:bbbb:abce::/64 where 2001:db8:bbbb:abce:: is the network address and 64 is the the prefix length. The remaining 64 bits will be derived from the EUI-64 (two middle bytes will be removed). You can also simply create an edge router in one of the network nodes: you have to enable routing and set the appropriate forwarding rules, as shown in contiki-init-net.c. Then you have to add the corresponding rule on your machine, for example: route -A inet6 add 2001:db8:bbbb:abcd::/64 gw 2001:db8:bbbb:abce: 280:e102::8a. where 2001:db8:bbbb:abce:280:e102::6c is the address of the edge node and 2001:db8:bbbb:abcd::/64 is the lowpan address.