contiki/examples/ipv6/sky-websense
2014-12-01 20:13:09 +01:00
..
example-sky-websense.csc SkyByteRadio was replaced by Msp802154Radio 2014-07-23 15:42:59 +02:00
Makefile Cleanup of the Contiki network layer configuration. Now using CONTIKI_WITH_IPV6, CONTIKI_WITH_IPV4, and CONTIKI_WITH_RIME in makefiles, and UIP_CONF_IPV6, UIP_CONF_IPV4, UIP_CONF_RIME in c code. Now only the stacks that are used are compiled (via makefile MODULES). Make IPv6 the default network stack. 2014-12-01 20:13:09 +01:00
Makefile.target
project-conf.h A massive all-tree automated update of all double inclusion guard #defines that changes from using two underscores as a prefix, which are reserved, to not using two underscores as a prefix 2013-11-24 20:20:11 +01:00
README.md Rename to md 2013-03-26 23:15:37 +01:00
sky-websense.c Moved the sht11 driver to its own module 2014-01-26 23:20:30 +01:00
websense-remote.c
wget.c Updated include paths for the moved files under net/ 2014-01-26 23:20:23 +01:00
wget.h A massive all-tree automated update of all double inclusion guard #defines that changes from using two underscores as a prefix, which are reserved, to not using two underscores as a prefix 2013-11-24 20:20:11 +01:00

Sky websense

This example features a simple webserver running on top of the IPv6 contiki stack on Sky motes to provide sensor values, and with a RPL border router to bridge the sensor network to Internet.

To test the example in COOJA under Linux

  1. Start COOJA and load the simulation "example-sky-websense.csc"

    make TARGET=cooja example-sky-websense.csc

  2. Connect to the COOJA simulation using tunslip6:

    make connect-router-cooja

  3. You should now be able to browse to the nodes using your web browser: Router: http://[aaaa::0212:7401:0001:0101]/ Node 2: http://[aaaa::0212:7402:0002:0202]/

To run the example on real nodes under Linux

  1. Program the nodes with the websense application

    make TARGET=sky sky-websense.upload

  2. Disconnect the nodes and program one node with the RPL border router

    cd ../rpl-border-router && make TARGET=sky border-router.upload

  3. Connect to the border router using tunslip6:

    make connect-router

  4. Reboot the router and note the router IP address

  5. You should now be able to browse to your router node using your web browser: http://[]/. On this page you should see a list of all accessible nodes with their IP adresses.