contiki/examples/galileo
Ricardo de Almeida Gonzaga ba09b47d65 galileo: Initialize pinmux in i2c-LSM9DS0 example
In order to ensure SCL and SDA are exported in the correct pins.
2015-12-21 08:06:14 -02:00
..
gpio-input.c
gpio-interrupt.c
gpio-output.c
i2c-LSM9DS0.c galileo: Initialize pinmux in i2c-LSM9DS0 example 2015-12-21 08:06:14 -02:00
Makefile
README

Galileo Specific Examples
=======================

This directory contains galileo-specific example applications to illustrate
how to use galileo APIs.

In order to build a application, you should set the EXAMPLE environment
variable to the name of the application you want to build. For instance, if
you want to build gpio-output application, run the following command:
$ make TARGET=galileo EXAMPLE=gpio-output

============
=   GPIO   =
============

GPIO Output
===========

This application shows how to use the GPIO driver APIs to manipulate output
pins. This application sets the GPIO 4 pin as output pin and toggles its
state at every half second.

For a visual effect, you should wire shield pin IO1 to a led in a protoboard.
Once the application is running, you should see a blinking LED.

GPIO Input
==========

This application shows how to use the GPIO driver APIs to manipulate input
pins. This application uses default galileo pinmux initialization and sets
the GPIO 5 (IO2) as output pin and GPIO 6 (IO3) as input. It toggles the
output pin state at every half second and checks the value on input pin.

GPIO Interrupt
==============

This application shows how to use the GPIO driver APIs to manipulate interrupt
pins. This application uses default galileo pinmux initialization and sets
the GPIO 5 (IO2) as output pin and GPIO 6 (IO3) as interrupt. It toggles the
output pin stat at every half second in order to emulate an interrupt. This
triggers an interrupt and the application callback is called. You can confirm
that though the UART output.

=======
= I2C =
=======

I2C LSM9DS0
===========
This application shows how to use I2C driver APIs to configure I2C Master
controller and communicate with LSM9DS0 sensor. At every 5 seconds, the
application reads the "who am I" register from gyroscope sensor and prints if
the register value matches the expected value described in the spec [1].

According to the sensor spec, to read the value in "who am I" register, we
should first perform an i2c write operation to select the register we want
to read from and then we perform the i2c read operation to actually read
the register contents.

The wiring setup is as follows (left column from Galileo and right column from LSM9DS0):
- 3.3v and Vin
- GND  and GND
- GND  and SDOG
- 3.3v and CSG
- SDA  and SDA
- SCL  and SCL

==============
= References =
==============

[1] http://www.st.com/st-web-ui/static/active/en/resource/technical/document/datasheet/DM00087365.pdf