C 2019 E.S. CHAPIN REPLACEMENT EXTENDER CARD FOR APPLE DOS COMPATIBILITY v 1.0 Ground yourself and then remove DOS card from Macintosh. 1. remove 2 screws and 2 holding post from DOS card then remove bracket 2. reinstall holding posts on DOS card so you don't lose them later 3. install brakcet and 2 screws on extender card on the side with female connector 4. connect extender card to DOS card Optionally if you have metal strips with 2 holes 0.8" or about 20.5mm apart, you can use that and pair of screws and nuts to secure the extension card to DOS card 5. reinstall DOS card 96mm by 95 mm <b>SUB-D Connectors</b><p> Harting<br> NorComp<br> <p> PREFIX :<br> H = High density<br> F = Female<br> M = Male<p> NUMBER: Number of pins<p> SUFFIX :<br> H = Horizontal<br> V = Vertical <br> P = Shield pin on housing<br> B = No mounting holes<br> S = Pins individually placeable (Single)<br> D = Direct mounting <p> <author>Created by librarian@cadsoft.de</author> <b>SUB-D</b> >NAME >VALUE 1 10 9 18 19 26 HDF26 CONEC Female <b>SUB-D</b> >NAME >VALUE 1 10 9 18 19 26 Male HDM26 CONEC <b>Mounting Holes and Pads</b><p> <author>Created by librarian@cadsoft.de</author> <b>MOUNTING PAD</b> 3.6 mm, round <b>EAGLE Design Rules</b> <p> Die Standard-Design-Rules sind so gewählt, dass sie für die meisten Anwendungen passen. Sollte ihre Platine besondere Anforderungen haben, treffen Sie die erforderlichen Einstellungen hier und speichern die Design Rules unter einem neuen Namen ab. <b>EAGLE Design Rules</b> <p> The default Design Rules have been set to cover a wide range of applications. Your particular design may have different requirements, so please make the necessary adjustments and save your customized design rules under a new name. Since Version 6.2.2 text objects can contain more than one line, which will not be processed correctly with this version.