From 01353d9b25cdf7b295e0aa3e3743adc65baeba35 Mon Sep 17 00:00:00 2001 From: Eric Helgeson Date: Mon, 1 Feb 2021 18:15:28 -0600 Subject: [PATCH] images --- docs/assembly.md | 12 +++++++----- 1 file changed, 7 insertions(+), 5 deletions(-) diff --git a/docs/assembly.md b/docs/assembly.md index e6586d6..264bfcd 100644 --- a/docs/assembly.md +++ b/docs/assembly.md @@ -10,22 +10,24 @@ Read through all instructions before starting. - Once on, check continuity of all connections. Fixing this after the BluePill is on will be difficult. - Ensure the SD card fits and you dont have too much solder on the sides or contacts 2. Solder the dioeds to the **bottom** of the board. Be sure they are flush as possible to the bottom. -[Diode Orientation](images/diodes.png) -3. Solder the header pins on to the BluePill. Then BluePill pill to the BlueSCSI PCB. + +![Diode Orientation](images/diodes.png) +1. Solder the header pins on to the BluePill. Then BluePill pill to the BlueSCSI PCB. - Correct orientation is having the USB connector of the BluePill should be over the SD Card holder. -4. Solder on the Resistor nets. Pin one is marked on the board and the resistors. +2. Solder on the Resistor nets. Pin one is marked on the board and the resistors. - 220 RNETS are closest to the BluePill - Note PIN one on each - they are opposite of eachtoher. See photo. - 330 RNETS are furthest from the BluePill - Note PIN one on each - they are opposite of eachtoher. See photo. -[Orientation RNETs and BluePill](images/orientation.png) + +![Orientation RNETs and BluePill](images/orientation.png) 1. Solder on the Termination Jumpers & place the jumpers on to enable Termiation 2. Solder the 50 Pin headers on. 1. Note Pin 1 and Box header on the silk screen. 3. Optional - Solder on the berg connector. Only needed if your machine does not supply enough power via the SCSI bus. 4. Optional - Solder on the debug headers near the SD card. Only nessissarry if re-programming. -[Fully Assembled](images/assembled.png) +![Fully Assembled](images/assembled.png) ### Version 1.0-b BOM