MacPlus_MiSTer/sys/hdmi_config.sv
2021-01-23 20:09:42 +08:00

239 lines
7.2 KiB
Systemverilog

module hdmi_config
(
// Host Side
input iCLK,
input iRST_N,
input dvi_mode,
input audio_96k,
input [1:0] limited,
input ypbpr,
output reg done,
// I2C Side
output I2C_SCL,
inout I2C_SDA
);
// Internal Registers/Wires
reg mI2C_GO = 0;
wire mI2C_END;
wire mI2C_ACK;
reg [15:0] LUT_DATA;
reg [7:0] LUT_INDEX = 0;
i2c #(50_000_000, 20_000) i2c_av
(
.CLK(iCLK),
.I2C_SCL(I2C_SCL), // I2C CLOCK
.I2C_SDA(I2C_SDA), // I2C DATA
.I2C_ADDR('h39), // 0x39 is the Slave Address of the ADV7513 chip!
.I2C_WLEN(1),
.I2C_WDATA1(init_data[LUT_INDEX][15:8]), // SUB_ADDR
.I2C_WDATA2(init_data[LUT_INDEX][7:0]), // DATA
.START(mI2C_GO), // START transfer
.READ(0),
.END(mI2C_END), // END transfer
.ACK(mI2C_ACK) // ACK
);
////////////////////// Config Control ////////////////////////////
always@(posedge iCLK or negedge iRST_N) begin
reg [1:0] mSetup_ST = 0;
if(!iRST_N) begin
LUT_INDEX <= 0;
mSetup_ST <= 0;
mI2C_GO <= 0;
done <= 0;
end else begin
if(init_data[LUT_INDEX] != 16'hFFFF) begin
case(mSetup_ST)
0: begin
mI2C_GO <= 1;
mSetup_ST <= 1;
end
1: if(~mI2C_END) mSetup_ST <= 2;
2: begin
mI2C_GO <= 0;
if(mI2C_END) begin
mSetup_ST <= 0;
if(!mI2C_ACK) LUT_INDEX <= LUT_INDEX + 8'd1;
end
end
endcase
end
else done <= 1;
end
end
////////////////////////////////////////////////////////////////////
///////////////////// Config Data LUT //////////////////////////
wire [15:0] init_data[82] =
'{
16'h9803, // ADI required Write.
{8'hD6, 8'b1100_0000}, // [7:6] HPD Control...
// 00 = HPD is from both HPD pin or CDC HPD
// 01 = HPD is from CDC HPD
// 10 = HPD is from HPD pin
// 11 = HPD is always high
16'h4110, // Power Down control
16'h9A70, // ADI required Write.
16'h9C30, // ADI required Write.
{8'h9D, 8'b0110_0001}, // [7:4] must be b0110!.
// [3:2] b00 = Input clock not divided. b01 = Clk divided by 2. b10 = Clk divided by 4. b11 = invalid!
// [1:0] must be b01!
16'hA2A4, // ADI required Write.
16'hA3A4, // ADI required Write.
16'hE0D0, // ADI required Write.
16'h35_40,
16'h36_D9,
16'h37_0A,
16'h38_00,
16'h39_2D,
16'h3A_00,
{8'h16, 8'b0011_1000}, // Output Format 444 [7]=0.
// [6] must be 0!
// Colour Depth for Input Video data [5:4] b11 = 8-bit.
// Input Style [3:2] b10 = Style 1 (ignored when using 444 input).
// DDR Input Edge falling [1]=0 (not using DDR atm).
// Output Colour Space RGB [0]=0.
{8'h17, 8'b01100010}, // Aspect ratio 16:9 [1]=1, 4:3 [1]=0
{8'h18, ypbpr ? 8'h86 : limited[0] ? 8'h8D : limited[1] ? 8'h8E : 8'h00}, // CSC Scaling Factors and Coefficients for RGB Full->Limited.
{8'h19, ypbpr ? 8'hDF : limited[0] ? 8'hBC : 8'hFE}, // Taken from table in ADV7513 Programming Guide.
{8'h1A, ypbpr ? 8'h1A : 8'h00}, // CSC Channel A.
{8'h1B, ypbpr ? 8'h3F : 8'h00},
{8'h1C, ypbpr ? 8'h1E : 8'h00},
{8'h1D, ypbpr ? 8'hE2 : 8'h00},
{8'h1E, ypbpr ? 8'h07 : 8'h01},
{8'h1F, ypbpr ? 8'hE7 : 8'h00},
{8'h20, ypbpr ? 8'h04 : 8'h00}, // CSC Channel B.
{8'h21, ypbpr ? 8'h1C : 8'h00},
{8'h22, ypbpr ? 8'h08 : limited[0] ? 8'h0D : 8'h0E},
{8'h23, ypbpr ? 8'h11 : limited[0] ? 8'hBC : 8'hFE},
{8'h24, ypbpr ? 8'h01 : 8'h00},
{8'h25, ypbpr ? 8'h91 : 8'h00},
{8'h26, ypbpr ? 8'h01 : 8'h01},
{8'h27, 8'h00},
{8'h28, ypbpr ? 8'h1D : 8'h00}, // CSC Channel C.
{8'h29, ypbpr ? 8'hAE : 8'h00},
{8'h2A, ypbpr ? 8'h1B : 8'h00},
{8'h2B, ypbpr ? 8'h73 : 8'h00},
{8'h2C, ypbpr ? 8'h06 : limited[0] ? 8'h0D : 8'h0E},
{8'h2D, ypbpr ? 8'hDF : limited[0] ? 8'hBC : 8'hFE},
{8'h2E, ypbpr ? 8'h07 : 8'h01},
{8'h2F, ypbpr ? 8'hE7 : 8'h00},
{8'h3B, 8'b0000_0000}, // Pixel repetition [6:5] b00 AUTO. [4:3] b00 x1 mult of input clock. [2:1] b00 x1 pixel rep to send to HDMI Rx.
16'h4000, // General Control Packet Enable
{8'h48, 8'b0000_1000}, // [6]=0 Normal bus order!
// [5] DDR Alignment.
// [4:3] b01 Data right justified (for YCbCr 422 input modes).
16'h49A8, // ADI required Write.
16'h4C00, // ADI required Write.
{8'h55, 8'b0001_0000}, // [7] must be 0!. Set RGB444 in AVinfo Frame [6:5], Set active format [4].
// AVI InfoFrame Valid [4].
// Bar Info [3:2] b00 Bars invalid. b01 Bars vertical. b10 Bars horizontal. b11 Bars both.
// Scan Info [1:0] b00 (No data). b01 TV. b10 PC. b11 None.
{8'h57, 1'b0, // [7] IT Content. 0 - No. 1 - Yes (type set in register h59).
3'b000, // [6:4] Color space (ignored for RGB)
(ypbpr | limited) ? 2'b01 : 2'b10, // [3:2] RGB Quantization range
2'b00}, // [1:0] Non-Uniform Scaled: 00 - None. 01 - Horiz. 10 - Vert. 11 - Both.
16'h7301,
{8'h94, 8'b1000_0000}, // [7]=1 HPD Interrupt ENabled.
16'h9902, // ADI required Write.
16'h9B18, // ADI required Write.
16'h9F00, // ADI required Write.
{8'hA1, 8'b0000_0000}, // [6]=1 Monitor Sense Power Down DISabled.
16'hA408, // ADI required Write.
16'hA504, // ADI required Write.
16'hA600, // ADI required Write.
16'hA700, // ADI required Write.
16'hA800, // ADI required Write.
16'hA900, // ADI required Write.
16'hAA00, // ADI required Write.
16'hAB40, // ADI required Write.
{8'hAF, 6'b0000_01,~dvi_mode,1'b0}, // [7]=0 HDCP Disabled.
// [6:5] must be b00!
// [4]=0 Current frame is unencrypted
// [3:2] must be b01!
// [1]=1 HDMI Mode.
// [0] must be b0!
16'hB900, // ADI required Write.
{8'hBA, 8'b0110_0000}, // [7:5] Input Clock delay...
// b000 = -1.2ns.
// b001 = -0.8ns.
// b010 = -0.4ns.
// b011 = No delay.
// b100 = 0.4ns.
// b101 = 0.8ns.
// b110 = 1.2ns.
// b111 = 1.6ns.
16'hBB00, // ADI required Write.
16'hDE9C, // ADI required Write.
16'hE460, // ADI required Write.
16'hFA7D, // Nbr of times to search for good phase
// (Audio stuff on Programming Guide, Page 66)...
{8'h0A, 8'b0000_0000}, // [6:4] Audio Select. b000 = I2S.
// [3:2] Audio Mode. (HBR stuff, leave at 00!).
{8'h0B, 8'b0000_1110}, //
{8'h0C, 8'b0000_0100}, // [7] 0 = Use sampling rate from I2S stream. 1 = Use samp rate from I2C Register.
// [6] 0 = Use Channel Status bits from stream. 1 = Use Channel Status bits from I2C register.
// [2] 1 = I2S0 Enable.
// [1:0] I2S Format: 00 = Standard. 01 = Right Justified. 10 = Left Justified. 11 = AES.
{8'h0D, 8'b0001_0000}, // [4:0] I2S Bit (Word) Width for Right-Justified.
{8'h14, 8'b0000_0010}, // [3:0] Audio Word Length. b0010 = 16 bits.
{8'h15, audio_96k, 7'b010_0000}, // I2S Sampling Rate [7:4]. b0000 = (44.1KHz). b0010 = 48KHz.
// Input ID [3:1] b000 (0) = 24-bit RGB 444 or YCrCb 444 with Separate Syncs.
// Audio Clock Config
16'h0100, //
audio_96k ? 16'h0230 : 16'h0218, // Set N Value 12288/6144
16'h0300, //
16'h0701, //
16'h0822, // Set CTS Value 74250
16'h090A, //
16'hFFFF // END
};
////////////////////////////////////////////////////////////////////
endmodule