!!   ------ THIS FILE IS AUTO_GENERATED! DO NOT MANUALLY UPDATE!!!
!!   ------ The native file is scsiloop.1. Re-run 'make docs' after updating


scsiloop(1)                                           General Commands Manual                                          scsiloop(1)

NAME
       scsiloop - Tool for testing the PiSCSI board with a loopback adapter installed

SYNOPSIS
       scsiloop [-L LOG_LEVEL]

DESCRIPTION
       scsiloop  Performs  a  self-test of the PiSCSI hardware to ensure that the board is functioning properly. In order for this
       tool to work, a special loopback cable MUST be attached to the PiSCSI SCSI connector.

       In addition to testing the GPIO signals, scsiloop will perform a self-test of the hardware timers that are built  into  the
       system on a chip (SoC).

       The loopback connections for the DB25 connector are shown here:

           |Pin | Name | Pin | Name |
           +----+------+-----+------+
           |  1 | REQ  | 13  | DB7  |
           |  2 | MSG  | 12  | DB6  |
           |  3 | I/O  | 11  | DB5  |
           |  4 | RST  | 10  | DB3  |
           |  5 | ACK  |  8  | DB0  |
           |  6 | BSY  | 20  | DBP  |
           | 15 | C/D  | 23  | DB4  |
           | 17 | ATN  | 22  | DB2  |
           | 19 | SEL  | 21  | DB1  |

OPTIONS
       -L LOG_LEVEL
              The piscsi log level (trace, debug, info, warn, err, off). The default log level is 'info'.

SEE ALSO
       scsictl(1), piscsi(1), scsimon(1)

       Full documentation is available at: <https://www.piscsi.com>

                                                                                                                       scsiloop(1)