mirror of https://github.com/akuker/RASCSI.git
Updated Dayna Port SCSI Link (markdown)
parent
f903eb4ce5
commit
42e5b82eb7
|
@ -227,7 +227,7 @@ One way to know that your DaynaPort interface is set up correctly locally, is th
|
|||
|
||||
# Atari ST/TT/Falcon Setup Instructions
|
||||
|
||||
The DaynaPort SCSI/Link emulation works with the MiNT drivers for the Atari ST. Some instructions for setting this up are available on the archived [Anodyne Software web page](https://web.archive.org/web/20180915114613/http://www.anodynesoftware.com/ethernet/main.htm).
|
||||
The DaynaPort SCSI/Link emulation works with plain TOS and STiNG, and also with the MiNT drivers for the Atari ST. Some instructions for setting this up are available on the archived [Anodyne Software web page](https://web.archive.org/web/20180915114613/http://www.anodynesoftware.com/ethernet/main.htm).
|
||||
|
||||
See also [this thread on Atari-Forums](https://www.atari-forum.com/viewtopic.php?p=425264&sid=d98c89b8f40e228621e617964177ce27#p425264) with steps to a successful setup on an Atari TT system.
|
||||
|
||||
|
@ -241,6 +241,8 @@ For using the emulation with TOS and STiNG this configuration in STING.PRT can b
|
|||
Port : Ethernet0
|
||||
ACTIVE=1 IP=0a0a1402 SUBMASK=ffffff00 MTU=1500 TYPE=1 MAC=00:80:19:10:98:e3
|
||||
```
|
||||
Uncomment the setup block that matches the network interface, e.g. eth0 or wlan0, you have configured piscsi with.
|
||||
|
||||
This is a matching ROUTE.TAB:
|
||||
```
|
||||
# Pi, eth0
|
||||
|
@ -251,6 +253,7 @@ This is a matching ROUTE.TAB:
|
|||
10.10.20.0 255.255.255.0 Ethernet0 0.0.0.0
|
||||
0.0.0.0 0.0.0.0 Ethernet0 10.10.20.1
|
||||
```
|
||||
Note that STiNG does not support DHCP and thus requires a hard-coded IP address.
|
||||
|
||||
# Troubleshooting and limitations
|
||||
- If the DaynaPort installer complains about a Network file in control panels you will need to use [ResEdit ](https://macintoshgarden.org/apps/resedit)to make that file visible, then move it out of the Control Panels folder and try the install again.
|
||||
|
|
Loading…
Reference in New Issue