mac-rom-simm-programmer/hal/board.h

/*
 * board.h
 *
 *  Created on: Nov 14, 2020
 *      Author: Doug
 */

#ifndef HAL_BOARD_H_
#define HAL_BOARD_H_

#include "gpio.h"
#include "spi.h"

// Commented-out functions should be static inline in each board-specific header file.
//GPIOPin Board_LEDPin(void);
#include "board_hw.h"

void Board_Init(void);
bool Board_BrownoutDetected(void);

#endif /* HAL_BOARD_H_ */
Break out code into a HAL, optimize flash operations This makes the code pretty easily portable to other architectures if someone wants to make a more modern SIMM programmer. I also was pretty careful to split responsibilities of the different components and give the existing components better names. I'm pretty happy with the organization of the code now. As part of this change I have also heavily optimized the code. In particular, the read and write cycle routines are very important to the overall performance of the programmer. In these routines I had to make some tradeoffs of code performance versus prettiness, but the overall result is much faster programming. Some of these performance changes are the result of what I discovered when I upgraded my AVR compiler. I discovered that it is smarter at looking at 32-bit variables when I use a union instead of bitwise operations. I also shaved off more CPU cycles by carefully making a few small tweaks. I added a bypass for the "program only some chips" mask, because it was adding unnecessary CPU cycles for a feature that is rarely used. I removed the verification feature from the write routine, because we can always verify the data after the write chunk is complete, which is more efficient. I also added assumptions about the initial/final state of the CS/OE/WE pins, which allowed me to remove more valuable CPU cycles from the read/write cycle routines. There are also a few enormous performance optimizations I should have done a long time ago: 1) The code was only handling one received byte per main loop iteration. Reading every byte available cut nearly a minute off of the 8 MB programming time. 2) The code wasn't taking advantage of the faster programming command available in the chips used on the 8 MB SIMM. The end result of all of these optimizations is I have programming time of the 8 MB SIMM down to 3:31 (it used to be 8:43). Another minor issue I fixed: the Micron SIMM chip identification wasn't working properly. It was outputting the manufacturer ID again instead of the device ID. 2020-11-18 05:03:32 +00:00			`/*`
			`* board.h`
			`*`
			`* Created on: Nov 14, 2020`
			`* Author: Doug`
			`*/`

			`#ifndef HAL_BOARD_H_`
			`#define HAL_BOARD_H_`

			`#include "gpio.h"`
			`#include "spi.h"`

			`// Commented-out functions should be static inline in each board-specific header file.`
			`//GPIOPin Board_LEDPin(void);`
			`#include "board_hw.h"`

			`void Board_Init(void);`
			`bool Board_BrownoutDetected(void);`

			`#endif /* HAL_BOARD_H_ */`