The first packet the one sec mode should send is a mode 1 real time packet, same as GET_REAL_TIME.
A mode 2 packet is the same but doesn't include the time.
They are incomplete or unused (includes cmd and count but not the data and the count isn't used). Might as well get everything from the class fields in_buf and in_count.
GET_REAL_TIME was using the wrong offset and wasn't setting out_count.
May need to add time zone offset which could be different between host and guest.
get-time and set-time can be tested in Open Firmware.
SET_REAL_TIME is used by the Date/Time Control Panel when you change the date.
It is unknown what method Mac OS uses to get the time at boot. Mac OS 8.6 does not use GET_REAL_TIME during boot, so the time is left as 12:00 AM Jan 1, 1904.
Last step of CMD_COMPLETE_STEPS includes INTSTAT_SO to indicate to CurioSCSIController::fsmCompleting that it returned both a status byte and a message byte in the FIFO.
- For pdm/amic, real_dma_xfer is called when SCSI_DMA_Ctrl has the run bit set.
- For tnt/grandcentral, dma_wait is called when the DBDMA is started (run bit is set). It will call real_dma_xfer when the phase and sequence are DATA_IN/RCV_DATA or DATA_OUT/SEND_DATA.
- dma_wait and real_dma_xfer uses a one shot timer instead of a loop to continue doing DMA while also giving time to the CPU. This and the above changes handles the case where the DBDMA is started before setting up the transfer phase and sequence.
- dma_stop will stop the one shot timer when the DBDMA channel is stopped.
bytes_out is used instead of the removed cur_buf_cnt.
data_ptr is setup by prepare_data instead of process_command.
Not sure why scsicdrom doesn't set bytes_out in prepare_data.
- Use macros for reading 2 byte or 4 byte big endian data. block_size is assumed to be < 64K so WRITE_DWORD_BE_A will write two leading zeros.
- Scalar pass by value parameters don't need to be const.
- Remove some unnecessary locals.
Make it a separate method like scsihd. It also checks the incoming param size. If it's zero then the phase is not switched. Is that wrong? Still probably unfinished.
