It now actually checks the clock and tries to mix the audio in sync
relative to the clock, but the cpal output doesn't yet try to sync
to the StreamInstant time. Sound seems a lot better on chrome in
wasm, but and kind of better on firefox despite frame skipping not
being supported yet, but it's way slower for some reason (12fps)
It was previously only updating the frequency if the A0 registers
were written last, but now it works the way the rate code does, using
the cached register values to set the frequency whenever a register
is written to. It also stores the fnumber and block in the operator
which I guess would be needed eventually if I want to save and restore
state.
- The envelope generator wasn't working as it should have, minor issues
with the limits and whether to use 10-bit or 12-bit values (more to come)
- fixed issues with sustain level where it was always set to 0
- fixed release rate and levels to make them 5-bit and 10-bit numbers
respectively, so they match the others
- switched from SineWave to SquareWave and this alone made it go from
terrible and muddy to not that far off. I probably need to completely
change the output
- also included an attempt at removing HostData, still needed for an
interrupt that is triggered by user input
It does something, but doesn't work as it should. It could be a few
things including the on/off signal being too slow due to how time
works in the sample generation, but I wanted to at least commit what
I have. It seems to work roughly right according to the forum post
that describes the chip's operation in detail, but there could still
be some glaring bugs
The hope was that this would reduce the amount of copying and bit
shifting required by the frontend to get the data on screen, but
it doesn't seem to offer much advantage, surprisingly. I'll leave
it in though. There are a few other minor tweaks included here to
try to improve the performance a bit
It wasn't copying the frame data from the sources to the output frame
correctly, and there was a small period of zeros at the start of the
frame.
I also converted to using a vec of tuples for the two channels to
make it easier to reason about, since some of the issues were related
to the differences sizes calculated from the clock based on the sample
rate
It's a bit weirdly implemented because the Addressable trait doesn't
have access to System, so it has to set a flag on the Bus which is
then checked during the step function in System to activate the
breakpoint if a watched memory location was written to
