Macintosh-HW/BlueSCSI
1
0
Fork 0
mirror of https://github.com/erichelgeson/BlueSCSI.git synced 2024-12-22 12:30:12 +00:00
Code Issues Projects Releases Wiki Activity

Cleanup

Browse Source
This commit is contained in:
Eric Helgeson 2021-02-01 18:28:45 -06:00
parent 01353d9b25
commit 439ca41f31
2 changed files with 9 additions and 10 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

19
docs/assembly.md
View File

@ -10,23 +10,22 @@ Read through all instructions before starting.
- Once on, check continuity of all connections. Fixing this after the BluePill is on will be difficult.
- Ensure the SD card fits and you dont have too much solder on the sides or contacts
2. Solder the dioeds to the **bottom** of the board. Be sure they are flush as possible to the bottom.
![Diode Orientation](images/diodes.png)
1. Solder the header pins on to the BluePill. Then BluePill pill to the BlueSCSI PCB.
3. Solder the header pins on to the BluePill. Then BluePill pill to the BlueSCSI PCB.
- Correct orientation is having the USB connector of the BluePill should be over the SD Card holder.
2. Solder on the Resistor nets. Pin one is marked on the board and the resistors.
- 220 RNETS are closest to the BluePill
4. Solder on the resistor nets. Pin one is marked on the board and the resistors.
- 220 RNETS (`RN1` & `RN3`) are closest to the BluePill
- Note PIN one on each - they are opposite of eachtoher. See photo.
- 330 RNETS are furthest from the BluePill
- 330 RNETS (`RN2` & `RN4`) are furthest from the BluePill
- Note PIN one on each - they are opposite of eachtoher. See photo.
![Orientation RNETs and BluePill](images/orientation.png)
1. Solder on the Termination Jumpers & place the jumpers on to enable Termiation
2. Solder the 50 Pin headers on.
5. Solder on the Termination Jumpers & place the jumpers on to enable Termiation
6. Solder the 50 Pin headers on.
1. Note Pin 1 and Box header on the silk screen.
3. Optional - Solder on the berg connector. Only needed if your machine does not supply enough power via the SCSI bus.
4. Optional - Solder on the debug headers near the SD card. Only nessissarry if re-programming.
7. Optional - Solder on the berg connector. Only needed if your machine does not supply enough power via the SCSI bus.
8. Optional - Solder on the debug headers near the SD card. Only nessissarry if re-programming.
### Fully Assembled
![Fully Assembled](images/assembled.png)
### Version 1.0-b BOM

BIN
docs/images/orientation.png
View File

Binary file not shown.
Side by Side Swipe Overlay

Before

Width:  |  Height:  |  Size: 571 KiB

After

Width:  |  Height:  |  Size: 488 KiB