Updated BlueSCSI 1.1 Desktop Assembly (markdown)

BlueSCSI-1.1-Desktop-Assembly.md

@@ -1,6 +1,61 @@
-1.1 Desktop Assembly
+1.1 Desktop Assembly (document a work in progress)
+
+BlueSCSI 1.0 A/B/C Assembly
+
+# Before you start
+Read through all instructions before starting.
+
+Verify you have all the components
+* Preprogrammed STM32 BluePill with 2x 20 pin headers
+* BlueSCSI 1.1 desktop PCB
+* 2x Diodes
+* 50 pin male SCSI connector
+* 2x 220ohm Resistor Networks
+* 2x 330ohm Resistor Networks
+* MicroSD Socket
+* Berg connector
+* 2x 2 pin headers with jumpers
+* 2x 2 pin headers for LEDs(optional)
+* 2x resistors for LEDs(optional)
+* 3d printed bracket
+
+# Videos
+
+None yet
+
+# Building
+
+1. Solder the surface mount SD Card holder onto the board. Use the [Drag Solder](https://www.youtube.com/watch?v=Z_KL4fWOMug) technique
+   * Once on, check continuity of all connections. Fixing this after the BluePill is on will be difficult.
+   * Ensure the SD card fits and you dont have too much solder on the sides or contacts - if you do, you can use solder wick to clean some off
+
+2. Solder the 2 diode to the board, ensure it is as flush with the PCB as possible.  Trim the excess legs
+
+3. Solder on the resistor nets ensuring correct placement and orientation
+
+4. Solder on the Termination Jumpers & place the jumpers on to enable Termination
+5. Solder the 50 Pin headers on.
+   * Note Pin 1 and Box header on the silk screen.
+6. Solder on the berg connector. Only needed if your machine does not supply enough power via the SCSI bus, but recommended to solder on if you have the connector
+7. Optional - solder on resistors for the LED for both power and activity.  
+
+8. Optional - Solder on 2 pin headers for the LED
+
+9. Solder the header pins on to the BluePill. Then BluePill pill to the BlueSCSI PCB.
+   * Correct orientation is having the USB connector of the BluePill facing AWAY from the SD holder.
+   * **NOTE:** Consider adding headers to the board if you would like to have the BluePill removable.
+
+
+## Fully Assembled
+![](https://github.com/erichelgeson/BlueSCSI/raw/main/docs/images/assembled.png)
+
+
+9. [Configure it](https://github.com/erichelgeson/BlueSCSI/wiki/Usage)
+10. Test it!
+   * Plug it into your favorite Mac, run a benchmark with SCSI Director Pro, play some Lemmings, write a document in ClarisWorks, enjoy!
+
+
 
-*Work in progress*
 
 
 ## Built