This enables the rematerialization of some R600 MOV instructions in the
RegisterCoalescer and adds a testcase for r235668.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@235675 91177308-0d34-0410-b5e6-96231b3b80d8
When the base register index of the vector plus the constant offset
was less than zero, we were passing the wrong base register to the indirect
addressing instruction.
In this case, we need to set the base register to v0 and then add
the computed (negative) index to m0.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@235641 91177308-0d34-0410-b5e6-96231b3b80d8
This pass will always try to insert llvm.SI.ifbreak intrinsics
in the same block that its conditional value is computed in. This is
a problem when conditions for breaks or continue are computed outside
of the loop, because the llvm.SI.ifbreak intrinsic ends up being inserted
outside of the loop.
This patch fixes this problem by inserting the llvm.SI.ifbreak
intrinsics in the loop header when the condition is computed outside
the loop.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@234891 91177308-0d34-0410-b5e6-96231b3b80d8
Revert "Remove default in fully-covered switch (to fix Clang -Werror -Wcovered-switch-default)"
Revert "R600: Add carry and borrow instructions. Use them to implement UADDO/USUBO"
Revert "LegalizeDAG: Try to use Overflow operations when expanding ADD/SUB"
Using overflow operations fails CodeGen/Generic/2011-07-07-ScheduleDAGCrash.ll
on hexagon, nvptx, and r600. Revert while I investigate.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@234768 91177308-0d34-0410-b5e6-96231b3b80d8
v2: tighten the sub64 tests
v3: rename to CARRY/BORROW
v4: fixup test cmdline
add known bits computation
use sign extend instead of sub 0,x
better add test
v5: remove redundant break
move lowering to separate functions
fix comments
Signed-off-by: Jan Vesely <jan.vesely@rutgers.edu>
Reviewers: arsenm
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@234759 91177308-0d34-0410-b5e6-96231b3b80d8
"Fix the MachineScheduler's logic for updating ready times for in-order.
Now the scheduler updates a node's ready time as soon as it is
scheduled, before releasing dependent nodes."
This fix was only made in one variant of the ScheduleDAGMI driver.
Francois de Ferriere reported the issue in the other bit of code where
it was also needed.
I never got around to coming up with a test case, but it's an
obvious fix that shouldn't be delayed any longer.
I'll try to refactor this code a little better.
I did verify performance on a wide variety of targets and saw no
negative impact with this fix.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@233366 91177308-0d34-0410-b5e6-96231b3b80d8
V_FRACT is buggy on SI.
R600-specific code is left intact.
v2: drop the multiclass, use complex VOP3 patterns
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@233075 91177308-0d34-0410-b5e6-96231b3b80d8
This enables very common cases to switch to the
smaller encoding.
All of the standard LLVM canonicalizations of comparisons
are the opposite of what we want. Compares with constants
are moved to the RHS, but the first operand can be an inline
immediate, literal constant, or SGPR using the 32-bit VOPC
encoding.
There are additional bad canonicalizations that should
also be fixed, such as canonicalizing ge x, k to gt x, (k + 1)
if this makes k no longer an inline immediate value.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@232988 91177308-0d34-0410-b5e6-96231b3b80d8
This function assumed that SMRD instructions always have immediate
offsets, which is not always the case.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@232957 91177308-0d34-0410-b5e6-96231b3b80d8
This should bring the windows bots back.
It is a bit ugly, but it is better than what we had before: The triple would
say that the object format was COFF, but llc/llvm-mc would produce an ELF.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@232683 91177308-0d34-0410-b5e6-96231b3b80d8
There are no opcodes for this. This also adds a test case.
v2: make test more robust
Patch by: Grigori Goronzy
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@232386 91177308-0d34-0410-b5e6-96231b3b80d8
Similar to gep (r230786) and load (r230794) changes.
Similar migration script can be used to update test cases, which
successfully migrated all of LLVM and Polly, but about 4 test cases
needed manually changes in Clang.
(this script will read the contents of stdin and massage it into stdout
- wrap it in the 'apply.sh' script shown in previous commits + xargs to
apply it over a large set of test cases)
import fileinput
import sys
import re
rep = re.compile(r"(getelementptr(?:\s+inbounds)?\s*\()((<\d*\s+x\s+)?([^@]*?)(|\s*addrspace\(\d+\))\s*\*(?(3)>)\s*)(?=$|%|@|null|undef|blockaddress|getelementptr|addrspacecast|bitcast|inttoptr|zeroinitializer|<|\[\[[a-zA-Z]|\{\{)", re.MULTILINE | re.DOTALL)
def conv(match):
line = match.group(1)
line += match.group(4)
line += ", "
line += match.group(2)
return line
line = sys.stdin.read()
off = 0
for match in re.finditer(rep, line):
sys.stdout.write(line[off:match.start()])
sys.stdout.write(conv(match))
off = match.end()
sys.stdout.write(line[off:])
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@232184 91177308-0d34-0410-b5e6-96231b3b80d8
Instead print them as part of the $dst operand. The AsmMatcher
requires the 32-bit and 64-bit encodings have the same mnemonic in
order to parse them correctly.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@232105 91177308-0d34-0410-b5e6-96231b3b80d8
This is based on the following equivalences:
select(C0 & C1, X, Y) <=> select(C0, select(C1, X, Y), Y)
select(C0 | C1, X, Y) <=> select(C0, X, select(C1, X, Y))
Many target cannot perform and/or on the CPU flags and therefore the
right side should be choosen to avoid materializign the i1 flags in an
integer register. If the target can perform this operation efficiently
we normalize to the left form.
Differential Revision: http://reviews.llvm.org/D7622
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@231507 91177308-0d34-0410-b5e6-96231b3b80d8
Essentially the same as the GEP change in r230786.
A similar migration script can be used to update test cases, though a few more
test case improvements/changes were required this time around: (r229269-r229278)
import fileinput
import sys
import re
pat = re.compile(r"((?:=|:|^)\s*load (?:atomic )?(?:volatile )?(.*?))(| addrspace\(\d+\) *)\*($| *(?:%|@|null|undef|blockaddress|getelementptr|addrspacecast|bitcast|inttoptr|\[\[[a-zA-Z]|\{\{).*$)")
for line in sys.stdin:
sys.stdout.write(re.sub(pat, r"\1, \2\3*\4", line))
Reviewers: rafael, dexonsmith, grosser
Differential Revision: http://reviews.llvm.org/D7649
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@230794 91177308-0d34-0410-b5e6-96231b3b80d8
One of several parallel first steps to remove the target type of pointers,
replacing them with a single opaque pointer type.
This adds an explicit type parameter to the gep instruction so that when the
first parameter becomes an opaque pointer type, the type to gep through is
still available to the instructions.
* This doesn't modify gep operators, only instructions (operators will be
handled separately)
* Textual IR changes only. Bitcode (including upgrade) and changing the
in-memory representation will be in separate changes.
* geps of vectors are transformed as:
getelementptr <4 x float*> %x, ...
->getelementptr float, <4 x float*> %x, ...
Then, once the opaque pointer type is introduced, this will ultimately look
like:
getelementptr float, <4 x ptr> %x
with the unambiguous interpretation that it is a vector of pointers to float.
* address spaces remain on the pointer, not the type:
getelementptr float addrspace(1)* %x
->getelementptr float, float addrspace(1)* %x
Then, eventually:
getelementptr float, ptr addrspace(1) %x
Importantly, the massive amount of test case churn has been automated by
same crappy python code. I had to manually update a few test cases that
wouldn't fit the script's model (r228970,r229196,r229197,r229198). The
python script just massages stdin and writes the result to stdout, I
then wrapped that in a shell script to handle replacing files, then
using the usual find+xargs to migrate all the files.
update.py:
import fileinput
import sys
import re
ibrep = re.compile(r"(^.*?[^%\w]getelementptr inbounds )(((?:<\d* x )?)(.*?)(| addrspace\(\d\)) *\*(|>)(?:$| *(?:%|@|null|undef|blockaddress|getelementptr|addrspacecast|bitcast|inttoptr|\[\[[a-zA-Z]|\{\{).*$))")
normrep = re.compile( r"(^.*?[^%\w]getelementptr )(((?:<\d* x )?)(.*?)(| addrspace\(\d\)) *\*(|>)(?:$| *(?:%|@|null|undef|blockaddress|getelementptr|addrspacecast|bitcast|inttoptr|\[\[[a-zA-Z]|\{\{).*$))")
def conv(match, line):
if not match:
return line
line = match.groups()[0]
if len(match.groups()[5]) == 0:
line += match.groups()[2]
line += match.groups()[3]
line += ", "
line += match.groups()[1]
line += "\n"
return line
for line in sys.stdin:
if line.find("getelementptr ") == line.find("getelementptr inbounds"):
if line.find("getelementptr inbounds") != line.find("getelementptr inbounds ("):
line = conv(re.match(ibrep, line), line)
elif line.find("getelementptr ") != line.find("getelementptr ("):
line = conv(re.match(normrep, line), line)
sys.stdout.write(line)
apply.sh:
for name in "$@"
do
python3 `dirname "$0"`/update.py < "$name" > "$name.tmp" && mv "$name.tmp" "$name"
rm -f "$name.tmp"
done
The actual commands:
From llvm/src:
find test/ -name *.ll | xargs ./apply.sh
From llvm/src/tools/clang:
find test/ -name *.mm -o -name *.m -o -name *.cpp -o -name *.c | xargs -I '{}' ../../apply.sh "{}"
From llvm/src/tools/polly:
find test/ -name *.ll | xargs ./apply.sh
After that, check-all (with llvm, clang, clang-tools-extra, lld,
compiler-rt, and polly all checked out).
The extra 'rm' in the apply.sh script is due to a few files in clang's test
suite using interesting unicode stuff that my python script was throwing
exceptions on. None of those files needed to be migrated, so it seemed
sufficient to ignore those cases.
Reviewers: rafael, dexonsmith, grosser
Differential Revision: http://reviews.llvm.org/D7636
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@230786 91177308-0d34-0410-b5e6-96231b3b80d8
The expansion code does the same thing. Since
the operands were not defined with the correct
types, this has the side effect of fixing operand
folding since the expanded pseudo would never use
SGPRs or inline immediates.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@230072 91177308-0d34-0410-b5e6-96231b3b80d8
This enables a few useful combines that used to only
use fma.
Also since v_mad_f32 apparently does not support denormals,
disable the existing cases that are custom handled if they are
requested.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@230071 91177308-0d34-0410-b5e6-96231b3b80d8
We were trying to fold into implicit uses, which led to out of bounds
access of the MCInstrDesc::OpInfo arrray.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@229533 91177308-0d34-0410-b5e6-96231b3b80d8
