BlueSCSI/docs/assembly.md
TomRBarber 302c98a267
Update assembly.md
fided typo
2021-10-08 20:51:46 -04:00

3.2 KiB

Assembly

Before you start

Read through all instructions before starting.

Videos

The community has created a few assembly videos:

Building

  1. Solder on the surface mount SD Card holder. Use the Drag Solder technique.
    • Once on, check continuity of all connections. Fixing this after the BluePill is on will be difficult.
    • Ensure the SD card fits and you dont have too much solder on the sides or contacts
  2. Solder the diodes to the bottom of the board. Be sure they are flush as possible to the bottom. Diode Orientation
  3. Solder the header pins on to the BluePill. Then BluePill pill to the BlueSCSI PCB.
    • Correct orientation is having the USB connector of the BluePill should be over the SD Card holder.
    • NOTE: Consider adding headers to the board if you would like to have the BluePill removable.
  4. Solder on the resistor nets. Pin one is marked on the board and the resistors.
    • 220 RNETS (RN1 & RN3) are closest to the BluePill
      • NOTE PIN one on each - they are opposite of eachtoher. See photo.
    • 330 RNETS (RN2 & RN4) are furthest from the BluePill
      • NOTE PIN one on each - they are opposite of eachtoher. See photo. Orientation RNETs and BluePill
  5. Solder on the Termination Jumpers & place the jumpers on to enable Termiation
  6. Solder the 50 Pin headers on.
    1. Note Pin 1 and Box header on the silk screen.
  7. Optional - Solder on the berg connector. Only needed if your machine does not supply enough power via the SCSI bus.
  8. Optional - Solder on the debug headers near the SD card. Only nessissarry if re-programming.

Fully Assembled

Fully Assembled

Version 1.0-b & 1.0-c BOM

Mouser Cart

https://www.mouser.com/ProjectManager/ProjectDetail.aspx?AccessID=c5cc83feff

Parts

STM32F103C8T6 (U1) aka BluePill board. Beware of fake/scams. Look for reviews. Amazon, ebay, etc.

Optional

Floppy/Berg Power header https://www.mouser.com/ProductDetail/571-1718254

  • Required if your machine does not supply power via TERM POWER. For example a Mac Plus or Mac with a Analog/PSU board that has not been recapped.