rather than deriving the StringRef from the Start and End SMLocs.
Using the Start and End SMLocs works fine for operands such as [Symbol], but
not for operands such as [Symbol + ImmDisp]. All existing test cases that
reference a variable exercise this patch.
rdar://13602265
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179109 91177308-0d34-0410-b5e6-96231b3b80d8
On PowerPC, non-vector loads and stores have r+i forms; however, in functions
with large stack frames these were not being used to access slots far from the
stack pointer because such slots were out of range for the signed 16-bit
immediate offset field. This increases register pressure because we need a
separate register for each offset (when the r+r form is used). By enabling
virtual base registers, we can deal with large stack frames without unduly
increasing register pressure.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179105 91177308-0d34-0410-b5e6-96231b3b80d8
The save area is twice as big and there is no struct return slot. The
stack pointer is always 16-byte aligned (after adding the bias).
Also eliminate the stack adjustment instructions around calls when the
function has a reserved stack frame.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179083 91177308-0d34-0410-b5e6-96231b3b80d8
The costs are overfitted so that I can still use the legalization factor.
For example the following kernel has about half the throughput vectorized than
unvectorized when compiled with SSE2. Before this patch we would vectorize it.
unsigned short A[1024];
double B[1024];
void f() {
int i;
for (i = 0; i < 1024; ++i) {
B[i] = (double) A[i];
}
}
radar://13599001
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179033 91177308-0d34-0410-b5e6-96231b3b80d8
PowerPC has a conditional branch to the link register (return) instruction: BCLR.
This should be used any time when we'd otherwise have a conditional branch to a
return. This adds a small pass, PPCEarlyReturn, which runs just prior to the
branch selection pass (and, importantly, after block placement) to generate
these conditional returns when possible. It will also eliminate unconditional
branches to returns (these happen rarely; most of the time these have already
been tail duplicated by the time PPCEarlyReturn is invoked). This is a nice
optimization for small functions that do not maintain a stack frame.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179026 91177308-0d34-0410-b5e6-96231b3b80d8
I've managed to convince myself that AArch64's acquire/release
instructions are sufficient to guarantee C++11's required semantics,
even in the sequentially-consistent case.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179005 91177308-0d34-0410-b5e6-96231b3b80d8
First, we should not cheat: fsel-based lowering of select_cc is a
finite-math-only optimization (the ISA manual, section F.3 of v2.06, makes
this clear, as does a note in our own README).
This also adds fsel-based lowering of EQ and NE condition codes. As it turned
out, fsel generation was covered by a grand total of zero regression test
cases. I've added some test cases to cover the existing behavior (which is now
finite-math only), as well as the new EQ cases.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@179000 91177308-0d34-0410-b5e6-96231b3b80d8
Integer return values are sign or zero extended by the callee, and
structs up to 32 bytes in size can be returned in registers.
The CC_Sparc64 CallingConv definition is shared between
LowerFormalArguments_64 and LowerReturn_64. Function arguments and
return values are passed in the same registers.
The inreg flag is also used for return values. This is required to handle
C functions returning structs containing floats and ints:
struct ifp {
int i;
float f;
};
struct ifp f(void);
LLVM IR:
define inreg { i32, float } @f() {
...
ret { i32, float } %retval
}
The ABI requires that %retval.i is returned in the high bits of %i0
while %retval.f goes in %f1.
Without the inreg return value attribute, %retval.i would go in %i0 and
%retval.f would go in %f3 which is a more efficient way of returning
%multiple values, but it is not ABI compliant for returning C structs.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178966 91177308-0d34-0410-b5e6-96231b3b80d8
64-bit SPARC v9 processes use biased stack and frame pointers, so the
current function's stack frame is located at %sp+BIAS .. %fp+BIAS where
BIAS = 2047.
This makes more local variables directly accessible via [%fp+simm13]
addressing.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178965 91177308-0d34-0410-b5e6-96231b3b80d8
There are certain PPC instructions into which we can fold a zero immediate
operand. We can detect such cases by looking at the register class required
by the using operand (so long as it is not otherwise constrained).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178961 91177308-0d34-0410-b5e6-96231b3b80d8
All arguments are formally assigned to stack positions and then promoted
to floating point and integer registers. Since there are more floating
point registers than integer registers, this can cause situations where
floating point arguments are assigned to registers after integer
arguments that where assigned to the stack.
Use the inreg flag to indicate 32-bit fragments of structs containing
both float and int members.
The three-way shadowing between stack, integer, and floating point
registers requires custom argument lowering. The good news is that
return values are passed in the exact same way, and we can share the
code.
Still missing:
- Update LowerReturn to handle structs returned in registers.
- LowerCall.
- Variadic functions.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178958 91177308-0d34-0410-b5e6-96231b3b80d8
The code emitter knows how to encode operands whose name matches one of
the encoding fields. If there is no match, the code emitter relies on
the order of the operand and field definitions to determine how operands
should be encoding. Matching by order makes it easy to accidentally break
the instruction encodings, so we prefer to match by name.
Reviewed-by: Christian König <christian.koenig@amd.com>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178930 91177308-0d34-0410-b5e6-96231b3b80d8
SITargetLowering::analyzeImmediate() was converting the 64-bit values
to 32-bit and then checking if they were an inline immediate. Some
of these conversions caused this check to succeed and produced
S_MOV instructions with 64-bit immediates, which are illegal.
v2:
- Clean up logic
Reviewed-by: Christian König <christian.koenig@amd.com>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178927 91177308-0d34-0410-b5e6-96231b3b80d8
On cores for which we know the misprediction penalty, and we have
the isel instruction, we can profitably perform early if conversion.
This enables us to replace some small branch sequences with selects
and avoid the potential stalls from mispredicting the branches.
Enabling this feature required implementing canInsertSelect and
insertSelect in PPCInstrInfo; isel code in PPCISelLowering was
refactored to use these functions as well.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178926 91177308-0d34-0410-b5e6-96231b3b80d8
The manual states that there is a minimum of 13 cycles from when the
mispredicted branch is issued to when the correct branch target is
issued.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178925 91177308-0d34-0410-b5e6-96231b3b80d8
During LTO, the target options on functions within the same Module may
change. This would necessitate resetting some of the back-end. Do this for X86,
because it's a Friday afternoon.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178917 91177308-0d34-0410-b5e6-96231b3b80d8
memory operands.
Essentially, this layers an infix calculator on top of the parsing state
machine. The scale on the index register is still expected to be an immediate
__asm mov eax, [eax + ebx*4]
and will not work with more complex expressions. For example,
__asm mov eax, [eax + ebx*(2*2)]
The plus and minus binary operators assume the numeric value of a register is
zero so as to not change the displacement. Register operands should never
be an operand for a multiply or divide operation; the scale*indexreg
expression is always replaced with a zero on the operand stack to prevent
such a case.
rdar://13521380
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178881 91177308-0d34-0410-b5e6-96231b3b80d8
SSE2 has efficient support for shifts by a scalar. My previous change of making
shifts expensive did not take this into account marking all shifts as expensive.
This would prevent vectorization from happening where it is actually beneficial.
With this change we differentiate between shifts of constants and other shifts.
radar://13576547
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178808 91177308-0d34-0410-b5e6-96231b3b80d8
On certain architectures we can support efficient vectorized version of
instructions if the operand value is uniform (splat) or a constant scalar.
An example of this is a vector shift on x86.
We can efficiently support
for (i = 0 ; i < ; i += 4)
w[0:3] = v[0:3] << <2, 2, 2, 2>
but not
for (i = 0; i < ; i += 4)
w[0:3] = v[0:3] << x[0:3]
This patch adds a parameter to getArithmeticInstrCost to further qualify operand
values as uniform or uniform constant.
Targets can then choose to return a different cost for instructions with such
operand values.
A follow-up commit will test this feature on x86.
radar://13576547
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178807 91177308-0d34-0410-b5e6-96231b3b80d8
BCL is normally a conditional branch-and-link instruction, but has
an unconditional form (which is used in the SjLj code, for example).
To make clear that this BCL instruction definition is specifically
the special unconditional form (which does not meaningfully take
a condition-register input), rename it to BCLalways.
No functionality change intended.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178803 91177308-0d34-0410-b5e6-96231b3b80d8
The DAGCombine logic that recognized a/sqrt(b) and transformed it into
a multiplication by the reciprocal sqrt did not handle cases where the
sqrt and the division were separated by an fpext or fptrunc.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178801 91177308-0d34-0410-b5e6-96231b3b80d8
It fixes following tests for Hexagon:
CodeGen/Generic/2003-07-29-BadConstSbyte.ll
CodeGen/Generic/2005-10-21-longlonggtu.ll
CodeGen/Generic/2009-04-28-i128-cmp-crash.ll
CodeGen/Generic/MachineBranchProb.ll
CodeGen/Generic/builtin-expect.ll
CodeGen/Generic/pr12507.ll
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178794 91177308-0d34-0410-b5e6-96231b3b80d8
At the time when the XCore backend was added there were some issues with
with overlapping register classes but these all seem to be fixed now.
Describing the register classes correctly allow us to get rid of a
codegen only instruction (LDAWSP_lru6_RRegs) and it means we can
disassemble ru6 instructions that use registers above r11.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178782 91177308-0d34-0410-b5e6-96231b3b80d8
The Thumb2SizeReduction pass avoids false CPSR dependencies, except it
still aggressively creates tMOVi8 instructions because they are so
common.
Avoid creating false CPSR dependencies even for tMOVi8 instructions when
the the CPSR flags are known to have high latency. This allows integer
computation to overlap floating point computations.
Also process blocks in a reverse post-order and propagate high-latency
flags to successors.
<rdar://problem/13468102>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178773 91177308-0d34-0410-b5e6-96231b3b80d8
