This project OpenSource, any advanced user may want to build their own board from scratch.
The board is mostly SMD, with a few through hole components.
Assembly
The recommended way is to get the SMD assembly done by your favorite PCB printer and add the through hole components by yourself.
I'm using JLBPCB for this project but there isn't anything specific so you may want to use your favorite one.
Through hole
A few components has been tested with the board, you can fin them on the following table:
| Connector |
Brand |
P/N |
Notes |
| ADB |
Lumberg |
TM 0508 A/4 |
|
| ADB |
TE Connectivity |
5749263-1 |
Nickel |
| ADB |
TE Connectivity |
5749181-1 |
Gold |
| Quadrature |
TE Connectivity |
2301843-1 |
|
| Quadrature |
TRU Components |
TC-6648084 |
|
You also need a 2.54mm 4 pin header and an 3 positions, Off/On, DIP switch.
If it helps, here is a Mouser Link
Flashing
Once assembled, the next step is to flash the board