access to bits). Use them in place of float and
double interfaces where appropriate.
First bits of x86 long double constants handling
(untested, probably does not work).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41858 91177308-0d34-0410-b5e6-96231b3b80d8
2. Lower calls to fabs and friends to FABS nodes etc unless the function has
internal linkage. Before we wouldn't lower if it had a definition, which
is incorrect. This allows us to compile:
define double @fabs(double %f) {
%tmp2 = tail call double @fabs( double %f )
ret double %tmp2
}
into:
_fabs:
fabs f1, f1
blr
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41805 91177308-0d34-0410-b5e6-96231b3b80d8
Use APFloat in UpgradeParser and AsmParser.
Change all references to ConstantFP to use the
APFloat interface rather than double. Remove
the ConstantFP double interfaces.
Use APFloat functions for constant folding arithmetic
and comparisons.
(There are still way too many places APFloat is
just a wrapper around host float/double, but we're
getting there.)
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41747 91177308-0d34-0410-b5e6-96231b3b80d8
labels are generated bracketing each call (not just
invokes). This is used to generate entries in
the exception table required by the C++ personality.
However it gets in the way of tail-merging. This
patch solves the problem by no longer placing labels
around ordinary calls. Instead we generate entries
in the exception table that cover every instruction
in the function that wasn't covered by an invoke
range (the range given by the labels around the invoke).
As an optimization, such entries are only generated for
parts of the function that contain a call, since for
the moment those are the only instructions that can
throw an exception [1]. As a happy consequence, we
now get a smaller exception table, since the same
region can cover many calls. While there, I also
implemented folding of invoke ranges - successive
ranges are merged when safe to do so. Finally, if
a selector contains only a cleanup, there's a special
shorthand for it - place a 0 in the call-site entry.
I implemented this while there. As a result, the
exception table output (excluding filters) is now
optimal - it cannot be made smaller [2]. The
problem with throw filters is that folding them
optimally is hard, and the benefit of folding them is
minimal.
[1] I tested that having trapping instructions (eg
divide by zero) in such a region doesn't cause trouble.
[2] It could be made smaller with the help of higher
layers, eg by having branch folding reorder basic blocks
ending in invokes with the same landing pad so they
follow each other. I don't know if this is worth doing.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41718 91177308-0d34-0410-b5e6-96231b3b80d8
Implement some constant folding in SelectionDAG and
DAGCombiner using APFloat. Remove double versions
of constructor and getValue from ConstantFPSDNode.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41664 91177308-0d34-0410-b5e6-96231b3b80d8
Add APFloat interfaces to ConstantFP, SelectionDAG.
Fix integer bit in double->APFloat conversion.
Convert LegalizeDAG to use APFloat interface in
ConstantFPSDNode uses.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41587 91177308-0d34-0410-b5e6-96231b3b80d8
gcc exception handling: if an exception unwinds through
an invoke, then execution must branch to the invoke's
unwind target. We previously tried to enforce this by
appending a cleanup action to every selector, however
this does not always work correctly due to an optimization
in the C++ unwinding runtime: if only cleanups would be
run while unwinding an exception, then the program just
terminates without actually executing the cleanups, as
invoke semantics would require. I was hoping this
wouldn't be a problem, but in fact it turns out to be the
cause of all the remaining failures in the LLVM testsuite
(these also fail with -enable-correct-eh-support, so turning
on -enable-eh didn't make things worse!). Instead we need
to append a full-blown catch-all to the end of each
selector. The correct way of doing this depends on the
personality function, i.e. it is language dependent, so
can only be done by gcc. Thus this patch which generalizes
the eh.selector intrinsic so that it can handle all possible
kinds of action table entries (before it didn't accomodate
cleanups): now 0 indicates a cleanup, and filters have to be
specified using the number of type infos plus one rather than
the number of type infos. Related gcc patches will cause
Ada to pass a cleanup (0) to force the selector to always
fire, while C++ will use a C++ catch-all (null).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41484 91177308-0d34-0410-b5e6-96231b3b80d8
- *Always* round up the size of the allocation to multiples of stack
alignment to ensure the stack ptr is never left in an invalid state after a dynamic_stackalloc.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@41132 91177308-0d34-0410-b5e6-96231b3b80d8
(constants are still not handled). Adds ConvertActions
to control fp-to-fp conversions (these are currently
defaulted for all other targets, so no changes there).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@40958 91177308-0d34-0410-b5e6-96231b3b80d8
This also changes the syntax for llvm.bswap, llvm.part.set, llvm.part.select, and llvm.ct* intrinsics. They are automatically upgraded by both the LLVM ASM reader and the bitcode reader. The test cases have been updated, with special tests added to ensure the automatic upgrading is supported.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@40807 91177308-0d34-0410-b5e6-96231b3b80d8
simply specify them as results and let scheduledag handle them. That
is, instead of
SDOperand Flag = DAG.getTargetNode(Opc, MVT::i32, MVT::Flag, ...)
SDOperand Result = DAG.getCopyFromReg(Chain, X86::EAX, MVT::i32, Flag)
Just write:
SDOperand Result = DAG.getTargetNode(Opc, MVT::i32, MVT::i32, ...)
And let scheduledag emit the move from X86::EAX to a virtual register.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@40710 91177308-0d34-0410-b5e6-96231b3b80d8
