This follows up Ulrich Weigand's work in PPCInstrInfo.td and
PPCInstr64Bit.td by doing the corresponding work for most of the
Altivec patterns. I have not been able to do anything for the
following classes of instructions:
(1) Vector logicals. These don't have corresponding intrinsics and
don't have a single obvious vector type. So far as I can tell I need
to leave these as VRRC. Affected instructions are: VAND, VANDC,
VNOR, VOR, VXOR, V_SET0.
(2) Instructions that make use of vector shuffle. The selection code
promotes all shuffles to v16i8, so any pattern that matches on a
shuffle is constrained. I haven't found any way to make the patterns
match on their natural types, so I plan to leave these as VRRC.
Affected instructions are: VMRG*, VSPLTB, VSPLTH, VSPLTW, VPKUHUM,
VPKUWUM.
No change in behavior is anticipated.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178277 91177308-0d34-0410-b5e6-96231b3b80d8
These are 64-bit load/store with byte-swap, and available on the P7 and the A2.
Like the similar instructions for 16- and 32-bit words, these are matched in the
target DAG-combine phase against load/store-bswap pairs.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178276 91177308-0d34-0410-b5e6-96231b3b80d8
requires that the return type of *r for all iterators r be reference,
where reference is defined in [iterator.requirements.general]/p11 as
iterator_traits<X>::reference, and X is the type of r.
But in CFG.h, the dereference operator of PredIterator and SuccIterator
return pointer, not reference.
Furthermore the nested type reference is value_type&, which is not the
type returned from operator*().
This patch simply makes the iterator::reference type value_type*, which
is what the operator*() returns, and then re-lables the return type as
reference.
From a functionality point of view, the only difference is that the
nested reference type is now value_type* instead of value_type&.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178240 91177308-0d34-0410-b5e6-96231b3b80d8
PPC ISA 2.06 (P7, A2, etc.) has a popcntd instruction. Add this instruction and
tell TTI about it so that popcount-loop recognition will know about it.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178233 91177308-0d34-0410-b5e6-96231b3b80d8
There were a few places where kill flags were not being set correctly, and
where 32-bit instruction variants were being used with 64-bit registers. After
r178180, this code was being triggered causing llc to assert.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178220 91177308-0d34-0410-b5e6-96231b3b80d8
This reverts commit 342d92c7a0.
Turns out we're going with a different schema design to represent
DW_TAG_imported_modules so we won't need this extra field.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178215 91177308-0d34-0410-b5e6-96231b3b80d8
form of call in preference to memory indirect on Atom.
In this case, the patch applies the optimization to the code for reloading
spilled registers.
The patch also includes changes to sibcall.ll and movgs.ll, which were
failing on the Atom buildbot after the first patch was applied.
This patch by Sriram Murali.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178193 91177308-0d34-0410-b5e6-96231b3b80d8
Made sure we were looking a correct section
Added Mips32/64 as an extra check
Updated llvm-objdump to generate symbolic info for Mips relocations
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178190 91177308-0d34-0410-b5e6-96231b3b80d8
These functions should have the same list of load/store instructions. Now that
all load/store forms have been normalized (to single instructions or pseudos)
they can be resynchronized.
Found by inspection, although hopefully this will improve optimization. I've
also added some comments.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178180 91177308-0d34-0410-b5e6-96231b3b80d8
indirect through a memory address is to load the memory address into
a register and then call indirect through the register.
This patch implements this improvement by modifying SelectionDAG to
force a function address which is a memory reference to be loaded
into a virtual register.
Patch by Sriram Murali.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178171 91177308-0d34-0410-b5e6-96231b3b80d8
This may be causing a failure on some buildbots:
Referencing function in another module!
tail call fastcc void @_ZL11EvaluateOpstPtRj(i16 zeroext %17, i16* %Vals, i32* %NumVals), !dbg !219
Referencing function in another module!
tail call fastcc void @_ZL11EvaluateOpstPtRj(i16 zeroext %19, i16* %Vals, i32* %NumVals), !dbg !221
Broken module found, compilation aborted!
Stack dump:
0. Running pass 'Function Pass Manager' on module 'ld-temp.o'.
1. Running pass 'Module Verifier' on function '@_ZL11EvaluateOpstPtRj'
clang: error: unable to execute command: Illegal instruction: 4
clang: error: linker command failed due to signal (use -v to see invocation)
<rdar://problem/13516485>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178156 91177308-0d34-0410-b5e6-96231b3b80d8
As far as simplify_type is concerned, there are 3 kinds of smart pointers:
* const correct: A 'const MyPtr<int> &' produces a 'const int*'. A
'MyPtr<int> &' produces a 'int *'.
* always const: Even a 'MyPtr<int> &' produces a 'const int*'.
* no const: Even a 'const MyPtr<int> &' produces a 'int*'.
This patch then does the following:
* Removes the unused specializations. Since they are unused, it is hard
to know which kind should be implemented.
* Make sure we don't drop const.
* Fix the default forwarding so that const correct pointer only need
one specialization.
* Simplifies the existing specializations.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178147 91177308-0d34-0410-b5e6-96231b3b80d8
6 more piglit tests.
Signed-off-by: Christian König <christian.koenig@amd.com>
Reviewed-by: Michel Dänzer <michel.daenzer@amd.com>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178145 91177308-0d34-0410-b5e6-96231b3b80d8
It seems that the Darwin PPC assembler requires r0 to be written as 0 when it
means 0 (at least in lwarx/stwcx.). Fixes PR15605.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178142 91177308-0d34-0410-b5e6-96231b3b80d8
This is a follow-up to r178073 (which should actually make target-customized
spilling work again).
I still don't have a regression test for this (but it would be good to have
one; Thumb 1 and Mips16 use this callback as well).
Patch by Richard Sandiford.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178137 91177308-0d34-0410-b5e6-96231b3b80d8
Signed-off-by: Christian König <christian.koenig@amd.com>
Reviewed-by: Michel Dänzer <michel.daenzer@amd.com>
Tested-by: Michel Dänzer <michel.daenzer@amd.com>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178127 91177308-0d34-0410-b5e6-96231b3b80d8
Signed-off-by: Christian König <christian.koenig@amd.com>
Reviewed-by: Michel Dänzer <michel.daenzer@amd.com>
Tested-by: Michel Dänzer <michel.daenzer@amd.com>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178126 91177308-0d34-0410-b5e6-96231b3b80d8
Signed-off-by: Christian König <christian.koenig@amd.com>
Reviewed-by: Michel Dänzer <michel.daenzer@amd.com>
Tested-by: Michel Dänzer <michel.daenzer@amd.com>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178125 91177308-0d34-0410-b5e6-96231b3b80d8
The R0 register can now be allocated because instructions
that cannot use R0 as a GPR have been appropriately marked.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@178123 91177308-0d34-0410-b5e6-96231b3b80d8
