The set of circumstances where the writeback register is allowed to be in the
list of registers is rather baroque, but I think this implements them all on
the assembly parsing side.
For disassembly, we still warn about an ARM-mode LDM even if the architecture
revision is < v7 (the required architecture information isn't available). It's
a silly instruction anyway, so hopefully no-one will mind.
rdar://problem/15223374
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@193185 91177308-0d34-0410-b5e6-96231b3b80d8
These were pretty straightforward instructions, with some assembly support
required for HLT.
The ARM assembler is keen to split the instruction mnemonic into a
(non-existent) 'H' instruction with the LT condition code. An exception for
HLT is needed.
HLT follows the same rules as BKPT when in IT blocks, so the special BKPT
hadling code has been adapted to handle HLT also.
Regression tests added including diagnostic tests for out of range immediates
and illegal condition codes, as well as negative tests for pre-ARMv8.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@190053 91177308-0d34-0410-b5e6-96231b3b80d8
- Instead of setting the suffixes in a bunch of places, just set one master
list in the top-level config. We now only modify the suffix list in a few
suites that have one particular unique suffix (.ml, .mc, .yaml, .td, .py).
- Aside from removing the need for a bunch of lit.local.cfg files, this enables
4 tests that were inadvertently being skipped (one in
Transforms/BranchFolding, a .s file each in DebugInfo/AArch64 and
CodeGen/PowerPC, and one in CodeGen/SI which is now failing and has been
XFAILED).
- This commit also fixes a bunch of config files to use config.root instead of
older copy-pasted code.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@188513 91177308-0d34-0410-b5e6-96231b3b80d8
In Thumb1, only one variant is supported: CPS{effect} {flags}
Thumb2 supports three:
CPS{effect}.W {flags}
CPS{effect} {flags} {mode}
CPS {mode}
Canonically, .W should be used only when ambiguity is present between encodings of different width.
The wide suffix is still accepted for the latter two forms via aliases.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@188071 91177308-0d34-0410-b5e6-96231b3b80d8
While the .td entry is nice and all, it takes a pretty gross hack in
ARMAsmParser::ParseInstruction() because of handling of other "subs"
instructions to get it to match. Ran it by Jim Grosbach and he said it was
about what he expected to make this work given the existing code.
rdar://14214063
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@187530 91177308-0d34-0410-b5e6-96231b3b80d8
Somehow forgot to git rm these two files. I believe I left the remaining
invalid* tests intentionally, though whether my reasons were sound is a
different matter.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@186663 91177308-0d34-0410-b5e6-96231b3b80d8
The tests were checking for barriers which the ARM ARM says they must execute
as a full system DMB/DSB, rather than that they're UNDEFINED and LLVM does in
fact represent them.
The tests happened to be passing because they were using a non-versioned ARM
triple which didn't have *any* DMB/DSB instructions.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@186662 91177308-0d34-0410-b5e6-96231b3b80d8
This allows "llvm-mc -disassemble" to accept two new features:
+ Using comma as a byte separator
+ Grouping bytes with '[' and ']' pairs.
The behaviour outside a [...] group is unchanged. But within the group once
llvm-mc encounters a true error, it stops rather than trying to resynchronise
the stream at the next byte. This is more useful for disassembly tests, where
we have an almost-instruction in mind and don't care what the misaligned
interpretation would be. Particularly if it means llvm-mc won't actually see
the next intended almost-instruction.
As a side effect, this means llvm-mc can disassemble its own -show-encoding
output if copy-pasted.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@186661 91177308-0d34-0410-b5e6-96231b3b80d8
This adds a new decoder table/namespace 'VFPV8', as these instructions have their
top 4 bits as 0b1111, while other Thumb instructions have 0b1110.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185642 91177308-0d34-0410-b5e6-96231b3b80d8
1. it should accept only 4-byte aligned addresses
2. the maximum offset should be 1020
3. it should be encoded with the offset scaled by two bits
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@185528 91177308-0d34-0410-b5e6-96231b3b80d8
When encoded to thumb, VFP instruction and VMOV/VDUP between scalar and
core registers, must have their predicate bit to 0b1110.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184707 91177308-0d34-0410-b5e6-96231b3b80d8
In thumb1, NOP is a pseudo-instruction equivalent to mov r8, r8.
However the disassembler should not use this alias.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184703 91177308-0d34-0410-b5e6-96231b3b80d8
The cdp2 instruction should have the same restrictions as cdp on the
co-processor registers.
VFP instructions on v8/AArch32 share the same encoding space as cdp2.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184445 91177308-0d34-0410-b5e6-96231b3b80d8
This fixes two previous issues:
- Negative offsets were not correctly disassembled
- The decoded opcodes were not the right one
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184180 91177308-0d34-0410-b5e6-96231b3b80d8
