The ARM backend did not expect LDRBi12 to hold a constant pool operand.
Allow for LLVM to deal with the instruction similar to how it deals with
LDRi12.
This fixes PR16215.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@183238 91177308-0d34-0410-b5e6-96231b3b80d8
The MOV64ri64i32 instruction required hacky MCInst lowering because it
was allocated as setting a GR64, but the eventual instruction ("movl")
only set a GR32. This converts it into a so-called "MOV32ri64" which
still accepts a (appropriate) 64-bit immediate but defines a GR32.
This is then converted to the full GR64 by a SUBREG_TO_REG operation,
thus keeping everyone happy.
This fixes a typo in the opcode field of the original patch, which
should make the legact JIT work again (& adds test for that problem).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@183068 91177308-0d34-0410-b5e6-96231b3b80d8
Namely, check if the target allows to fold more that one register in the
addressing mode and if yes, adjust the cost accordingly.
Prior to this commit, reg1 + scale * reg2 accesses were artificially preferred
to reg1 + reg2 accesses. Indeed, the cost model wrongly assumed that reg1 + reg2
needs a temporary register for the computation, whereas it was correctly
estimated for reg1 + scale * reg2.
<rdar://problem/13973908>
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@183021 91177308-0d34-0410-b5e6-96231b3b80d8
Unlike most -- hopefully "all other", but I'm still checking -- memory
instructions we support, LOAD REVERSED and STORE REVERSED may access
the memory location several times. This means that they are not suitable
for volatile loads and stores.
This patch is a prerequisite for better atomic load and store support.
The same principle applies there: almost all memory instructions we
support are inherently atomic ("block concurrent"), but LOAD REVERSED
and STORE REVERSED are exceptions.
Other instructions continue to allow volatile operands. I will add
positive "allows volatile" tests at the same time as the "allows atomic
load or store" tests.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@183002 91177308-0d34-0410-b5e6-96231b3b80d8
Now that 3.3 is branched, we are re-enabling virtual registers to help
iron out bugs before the next release. Some of the post-RA passes do
not play well with virtual registers, so we disable them for now. The
needed functionality of the PrologEpilogInserter pass is copied to a
new backend-specific NVPTXPrologEpilog pass.
The test for this commit is not breaking the existing tests.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182998 91177308-0d34-0410-b5e6-96231b3b80d8
The MOV64ri64i32 instruction required hacky MCInst lowering because it was
allocated as setting a GR64, but the eventual instruction ("movl") only set a
GR32. This converts it into a so-called "MOV32ri64" which still accepts a
(appropriate) 64-bit immediate but defines a GR32. This is then converted to
the full GR64 by a SUBREG_TO_REG operation, thus keeping everyone happy.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182991 91177308-0d34-0410-b5e6-96231b3b80d8
r182877 broke MCJIT tests on ARM and r182937 was working around another failure
by r182877.
This should make the ARM bots green.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182960 91177308-0d34-0410-b5e6-96231b3b80d8
The pattern the test originally checked for doesn't occur on other -mcpu
settings. On atom it's still there though slightly differently scheduled.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182933 91177308-0d34-0410-b5e6-96231b3b80d8
This test was failing on some hosts when an unexpected register was used for a
variable. This just extends the regexp to allow the new x86-64 registers.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182929 91177308-0d34-0410-b5e6-96231b3b80d8
Instead of having a bunch of separate MOV8r0, MOV16r0, ... pseudo-instructions,
it's better to use a single MOV32r0 (which will expand to "xorl %reg, %reg")
and obtain other sizes with EXTRACT_SUBREG and SUBREG_TO_REG. The encoding is
smaller and partial register updates can sometimes be avoided.
Until recently, this sequence was a barrier to rematerialization though. That
should now be fixed so it's an appropriate time to make the change.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182928 91177308-0d34-0410-b5e6-96231b3b80d8
The code to distinguish between unaligned and aligned addresses was
already there, so this is mostly just a switch-on-and-test process.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182920 91177308-0d34-0410-b5e6-96231b3b80d8
For COFF and MachO, sections semantically have relocations that apply to them.
That is not the case on ELF.
In relocatable objects (.o), a section with relocations in ELF has offsets to
another section where the relocations should be applied.
In dynamic objects and executables, relocations don't have an offset, they have
a virtual address. The section sh_info may or may not point to another section,
but that is not actually used for resolving the relocations.
This patch exposes that in the ObjectFile API. It has the following advantages:
* Most (all?) clients can handle this more efficiently. They will normally walk
all relocations, so doing an effort to iterate in a particular order doesn't
save time.
* llvm-readobj now prints relocations in the same way the native readelf does.
* probably most important, relocations that don't point to any section are now
visible. This is the case of relocations in the rela.dyn section. See the
updated relocation-executable.test for example.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182908 91177308-0d34-0410-b5e6-96231b3b80d8
In fact, we're probably going to support these flags in completely different
ways. So this test is no longer valid.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182899 91177308-0d34-0410-b5e6-96231b3b80d8
Fixes PR16146: gdb.base__call-ar-st.exp fails after
pre-RA-sched=source fixes.
Patch by Xiaoyi Guo!
This also fixes an unsupported dbg.value test case. Codegen was
previously incorrect but the test was passing by luck.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182885 91177308-0d34-0410-b5e6-96231b3b80d8
FastISel was only enabled for iOS ARM and Thumb2, this patch enables it
for ARM (not Thumb2) on Linux and NaCl.
Thumb2 support needs a bit more work, mainly around register class
restrictions.
The patch punts to SelectionDAG when doing TLS relocation on non-Darwin
targets. I will fix this and other FastISel-to-SelectionDAG failures in
a separate patch.
The patch also forces FastISel to retain frame pointers: iOS always
keeps them for backtracking (so emitted code won't change because of
this), but Linux was getting much worse code that was incorrect when
using big frames (such as test-suite's lencod). I'll also fix this in a
later patch, it will probably require a peephole so that FastISel
doesn't rematerialize frame pointers back-to-back.
The test changes are straightforward, similar to:
http://lists.cs.uiuc.edu/pipermail/llvm-commits/Week-of-Mon-20130513/174279.html
They also add a vararg test that got dropped in that change.
I ran all of test-suite on A15 hardware with --optimize-option=-O0 and
all the tests pass.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182877 91177308-0d34-0410-b5e6-96231b3b80d8
This allows rematerialization during register coalescing to handle
more cases involving operations like SUBREG_TO_REG which might need to
be rematerialized using sub-register indices.
For example, code like:
v1(GPR64):sub_32 = MOVZ something
v2(GPR64) = COPY v1(GPR64)
should be convertable to:
v2(GPR64):sub_32 = MOVZ something
but previously we just gave up in places like this
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182872 91177308-0d34-0410-b5e6-96231b3b80d8
This patch adds support for the CRJ and CGRJ instructions. Support for
the immediate forms will be a separate patch.
The architecture has a large number of comparison instructions. I think
it's generally better to concentrate on using the "best" comparison
instruction first and foremost, then only use something like CRJ if
CR really was the natual choice of comparison instruction. The patch
therefore opportunistically converts separate CR and BRC instructions
into a single CRJ while emitting instructions in ISelLowering.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182764 91177308-0d34-0410-b5e6-96231b3b80d8
When -ffast-math is in effect (on Linux, at least), clang defines
__FINITE_MATH_ONLY__ > 0 when including <math.h>. This causes the
preprocessor to include <bits/math-finite.h>, which renames the sqrt functions.
For instance, "sqrt" is renamed as "__sqrt_finite".
This patch adds the 3 new names in such a way that they will be treated
as equivalent to their respective original names.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182739 91177308-0d34-0410-b5e6-96231b3b80d8
When expanding unaligned Altivec loads, we use the decremented offset trick to
prevent page faults. Unfortunately, if we have a sequence of consecutive
unaligned loads, this leads to suboptimal code generation because the 'extra'
load from the first unaligned load can be combined with the base load from the
second (but only if the decremented offset trick is not used for the first).
Search up and down the chain, through loads and token factors, looking for
consecutive loads, and if one is found, don't use the offset reduction trick.
These duplicate loads are later combined to yield the desired sequence (in the
future, we might want a more-powerful chain search, but that will require some
changes to allow the combiner routines to access the AA object).
This should complete the initial implementation of the optimized unaligned
Altivec load expansion. There is some refactoring that should be done, but
that will happen when the unaligned store expansion is added.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182719 91177308-0d34-0410-b5e6-96231b3b80d8
The lvsl permutation control instruction is a function only of the alignment of
the pointer operand (relative to the 16-byte natural alignment of Altivec
vectors). As a result, multiple lvsl intrinsics where the operands differ by a
multiple of 16 can be combined.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@182708 91177308-0d34-0410-b5e6-96231b3b80d8
