This is a bit of a hack to make inline asm look more like call instructions.
It would be better to produce correct dead flags during isel.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105749 91177308-0d34-0410-b5e6-96231b3b80d8
%reg1025 = <sext> %reg1024
...
%reg1026 = SUBREG_TO_REG 0, %reg1024, 4
into this:
%reg1025 = <sext> %reg1024
...
%reg1027 = EXTRACT_SUBREG %reg1025, 4
%reg1026 = SUBREG_TO_REG 0, %reg1027, 4
The problem here is that SUBREG_TO_REG is there to assert that an implicit zext
occurs. It doesn't insert a zext instruction. If we allow the EXTRACT_SUBREG
here, it will give us the value after the <sext>, not the original value of
%reg1024 before <sext>.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105741 91177308-0d34-0410-b5e6-96231b3b80d8
register allocation.
Process all of the clobber lists at the end of the function, marking the
registers as used in MachineRegisterInfo.
This is necessary in case the calls clobber callee-saved registers (sic).
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105473 91177308-0d34-0410-b5e6-96231b3b80d8
replace an OpA with a widened OpB, it is possible to get new uses of OpA due to CSE
when recursively updating nodes. Since OpA has been processed, the new uses are
not examined again. The patch checks if this occurred and it it did, updates the
new uses of OpA to use OpB.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105453 91177308-0d34-0410-b5e6-96231b3b80d8
Check that all the instructions are in the same basic block, that the
EXTRACT_SUBREGs write to the same subregs that are being extracted, and that
the source and destination registers are in the same regclass. Some of
these constraints can be relaxed with a bit more work. Jakob suggested
that the loop that checks for subregs when NewSubIdx != 0 should use the
"nodbg" iterator, so I made that change here, too.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105437 91177308-0d34-0410-b5e6-96231b3b80d8
registers it defines then interfere with an existing preg live range.
For instance, if we had something like these machine instructions:
BB#0
... = imul ... EFLAGS<imp-def,dead>
test ..., EFLAGS<imp-def>
jcc BB#2 EFLAGS<imp-use>
BB#1
... ; fallthrough to BB#2
BB#2
... ; No code that defines EFLAGS
jcc ... EFLAGS<imp-use>
Machine sink will come along, see that imul implicitly defines EFLAGS, but
because it's "dead", it assumes that it can move imul into BB#2. But when it
does, imul's "dead" imp-def of EFLAGS is raised from the dead (a zombie) and
messes up the condition code for the jump (and pretty much anything else which
relies upon it being correct).
The solution is to know which pregs are live going into a basic block. However,
that information isn't calculated at this point. Nor does the LiveVariables pass
take into account non-allocatable physical registers. In lieu of this, we do a
*very* conservative pass through the basic block to determine if a preg is live
coming out of it.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105387 91177308-0d34-0410-b5e6-96231b3b80d8
expansion is the same as that used by LegalizeDAG.
The resulting code sucks in terms of performance/codesize on x86-32 for a
64-bit operation; I haven't looked into whether different expansions might be
better in general.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105378 91177308-0d34-0410-b5e6-96231b3b80d8
spills and reloads.
This means that a partial define of a register causes a reload so the other
parts of the register are preserved.
The reload can be prevented by adding an <imp-def> operand for the full
register. This is already done by the coalescer and live interval analysis where
relevant.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105369 91177308-0d34-0410-b5e6-96231b3b80d8
register updates.
These operands tell the spiller that the other parts of the partially defined
register are don't-care, and a reload is not necessary.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105361 91177308-0d34-0410-b5e6-96231b3b80d8
instruction defines subregisters.
Any existing subreg indices on the original instruction are preserved or
composed with the new subreg index.
Also substitute multiple operands mentioning the original register by using the
new MachineInstr::substituteRegister() function. This is necessary because there
will soon be <imp-def> operands added to non read-modify-write partial
definitions. This instruction:
%reg1234:foo = FLAP %reg1234<imp-def>
will reMaterialize(%reg3333, bar) like this:
%reg3333:bar-foo = FLAP %reg333:bar<imp-def>
Finally, replace the TargetRegisterInfo pointer argument with a reference to
indicate that it cannot be NULL.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105358 91177308-0d34-0410-b5e6-96231b3b80d8
backends and removes the virtual declaration. With that out of the way
I should be able to cleanup one backend at a time.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105321 91177308-0d34-0410-b5e6-96231b3b80d8
The comment about ordering of subreg indices is no longer true.
This exposed a bug in the new substVirtReg method that is also fixed.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105294 91177308-0d34-0410-b5e6-96231b3b80d8
handle structs passed by value via an extract/insert pair, as a bitcast
won't work on a struct. rdar://7742824
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105280 91177308-0d34-0410-b5e6-96231b3b80d8
that are too large. This causes the freebsd bootloader to be too
large apparently.
It's unclear if this should be an -Os or -Oz thing. Thoughts welcome.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105228 91177308-0d34-0410-b5e6-96231b3b80d8
shouldn't have a TargetLoweringInfo member. And FunctionLoweringInfo::set
doesn't needs its EnableFastISel argument.
git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@105101 91177308-0d34-0410-b5e6-96231b3b80d8
