David Blaikie 6d9dbd5526 Debug Info: Simplify Frame Index handling in DBG_VALUE Machine Instructions
Rather than using the full power of target-specific addressing modes in
DBG_VALUEs with Frame Indicies, simply use Frame Index + Offset. This
reduces the complexity of debug info handling down to two
representations of values (reg+offset and frame index+offset) rather
than three or four.

Ideally we could ensure that frame indicies had been eliminated by the
time we reached an assembly or dwarf generation, but I haven't spent the
time to figure out where the FIs are leaking through into that & whether
there's a good place to convert them. Some FI+offset=>reg+offset
conversion is done (see PrologEpilogInserter, for example) which is
necessary for some SelectionDAG assumptions about registers, I believe,
but it might be possible to make this a more thorough conversion &
ensure there are no remaining FIs no matter how instruction selection
is performed.

git-svn-id: https://llvm.org/svn/llvm-project/llvm/trunk@184066 91177308-0d34-0410-b5e6-96231b3b80d8
2013-06-16 20:34:15 +00:00
..
2012-09-29 21:43:49 +00:00
2012-10-16 07:16:47 +00:00
2012-10-19 08:23:06 +00:00
2013-05-20 08:01:34 +00:00
2013-03-15 17:27:39 +00:00
2012-06-11 08:07:26 +00:00
2012-02-28 02:08:50 +00:00
2012-12-06 21:24:47 +00:00
2013-06-09 12:36:57 +00:00
2012-12-06 02:29:29 +00:00
2012-06-15 21:32:12 +00:00
2012-09-29 21:43:49 +00:00
2011-12-19 23:26:44 +00:00
2012-09-29 21:43:49 +00:00
2012-09-29 21:43:49 +00:00
2012-09-29 21:43:49 +00:00
2012-09-29 21:43:49 +00:00
2012-09-29 21:43:49 +00:00
2011-11-29 23:09:16 +00:00
2012-09-29 21:43:49 +00:00
2013-04-11 12:32:23 +00:00
2011-07-26 20:49:44 +00:00